RECEIVER AND SERVO CONNECTIONS
Connect the servos to the receiver to perform the functions indicated:
The diagram shown is for aircraft models only. Additional servos may have to be purchased separately.
CHARGING THE Ni-Cd BATTERIES
The transmitter and receiver batteries included with your 6EXA system are rechargeable, Ni-Cd (nickel-cadmium, pronounced
ni
-
• kad) batteries. Ni-Cd batteries require special care and charging. Read the charging instructions carefully.
1. Connect the transmitter charging cord coming from the A/C wall charger to the charge jack in the right side of the
transmitter case. The receiver charging cord may be connected to the batteries two different ways: The charge cord may
be connected directly to the battery pack, or to the vacant charge connector (black) coming from the on/off switch in the
model. Charging “through the switch” is preferred as there will be no need to disconnect the battery.
2. Plug the A/C wall charger into a wall outlet. Note: If the wall outlet can be turned off by a switch in the room, be certain
the switch remains on after leaving the room. Otherwise, the batteries will not be charged!
3. The LEDs (light-emitting diodes) should light red, indicating that current is flowing and the batteries are being charged.
Discharged batteries will take about 15 hours to fully charge. If using an aftermarket fast charger, be certain to follow
the manufacturer’s instructions provided with the charger so you do not overcharge the batteries. NEVER charge
NOTE: The batteries are supplied partially charged but will require a full, overnight charge before the model may be flown.
7
Receiver
output Function
channel
1 Aileron -or- right flaperon -or- right elevon (for tailless models)
2 Elevator -or- left ruddervator (for V-tail models) -or- left elevon (for tailless models)
3 Throttle
4 Rudder -or- right ruddervator (for V-tail models)
5 Retractable landing gear
6 Flap -or- left flaperon
7 Not used
B/8 Receiver on/off switch (the plug colored red goes into the receiver)
Flap (or 2nd
Flaperon) Servo
(CH6)
Gear Servo
(CH5)
Rudder Servo
(CH4)
Throttle Servo
(CH3)
Elevator Servo
(CH2)
Aileron Servo
(CH1)
Receiver
Charging
Jack
(Black)
Switch
Harness
To Battery
(Red)
