Bedienungsanleitung Futaba 6XA (Seite 18 von 64) (Englisch)

28989

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

Flying Safety

To ensure the safety of yourself and others, please observe the following precautions:

Ni-cd Battery

Charge the Batteries! Don't forget to recharge the batteries before each flying session. A battery low

in charge will soon die, causing loss of control and a crash. Plug in the charger that comes in this system

and hook up the transmitter and airborne batteries the day before a planned flying session. When you

begin your flying session, keep track of how long the system’s been used, and monitor the transmitter’s

voltage display. Quit flying long before your batteries become low.

On-field charging of your batteries with a field charger is not recommended. A fast-charger may

overcharge the Ni-Cd batteries, causing overheating and a premature failure.

Flying field

We recommend that you fly at a recognized model airplane flying field. You can find model clubs

and fields by asking your nearest hobby dealer, or contacting the Academy of Model Aeronautics.

Always pay particular attention to the flying field’s rules, as well as the presence and location of

spectators, the wind direction, and any obstacles on the field. Be very careful flying in areas near power

lines, tall buildings, or communication facilities as there may be radio interference in their vicinity. If

you must fly at a site that is not a club field, be sure there are no other modelers flying within a two-mile

range, or you may lose control of your aircraft.

Once you arrive at the flying field …

Before flying, be sure that the frequency you intend to fly with is not in use, and secure any

frequency control device (pin, tag, etc.) for that frequency before turning on your transmitter. Never

believe that it’s possible to fly two or more models on the same frequency at the same time. Even though

there are different types of modulation (AM, FM, PCM), only one model may be flown on a single

frequency.

When you are ready to fly your model, position the throttle stick to its low speed position, or do

whatever is necessary to command your motor NOT to run. Then, you may turn on the transmitter power

followed by the receiver power. When you have finished flying, begin by turning off the receiver power,

then turn off the transmitter power. If you do not follow these procedures, you may damage your servos

or control surfaces, flood your motor, or in the case of electric-powered models, the motor may

unexpectedly turn on and cause a severe injury.

Before starting the engine, fully retract the transmitter antenna, power up the transmitter and receiver,

and check to be sure that the servos follow the movement of the sticks. If a servo operates abnormally,

don’t attempt to fly until you determine the cause of the problem. We recommend that you range-check

your system before each flying session. Have an observer verify that the system works with the

transmitter about 30 paces away with the transmitter antenna collapsed. Finally, before starting the

engine, be sure to check that the transmitter model memory is correct for the chosen model, and (for PCM

receivers only) that the fail safe system functions properly when the transmitter is shut off.

While you’re getting ready to fly, if you place your transmitter on the ground, be sure that the wind

won’t tip it over. If it is knocked over, the throttle stick may accidentally move causing the engine to race

unexpectedly.

Before taxiing, be sure to extend the transmitter antenna to its full length. A collapsed antenna will

reduce your flying range and may cause a loss of control. It is a good idea to avoid pointing the

transmitter antenna directly at the model at all times, since the signal is weakest in that direction.

Don’t fly in the rain!

Water or moisture may enter the transmitter through the antenna or stick openings and cause erratic

operation or loss of control. If you must fly in wet weather during a contest, be sure to cover your

transmitter with a plastic bag or waterproof barrier.

– 13 –

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba 6XA Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Futaba 6XA

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info