Bedienungsanleitung Futaba 9CAPsuper (Seite 35 von 109) (Englisch)

29007

Zoom out

Zoom in

Vorherige Seite

1/109

Nächste Seite

Dual/triple rates and exponential (D/R,EXP): assigns adjusted rates and exponential.

Dual/Triple Rates: reduce/increase the servo travel by flipping a switch, or (ACRO/

GLIDER) they can be engaged by any stick position. Dual rates affect the control listed,

such as aileron, not just a single (ex: channel 1) servo. For example, adjusting aileron

dual rate will affect both aileron servos when using FLAPERON or AIL-DIF, and both aile-

ron and elevator servos’ travel when using AILEVATOR or ELEVON or a CCPM helicopter.

Activation:

• Any S

WITCH, A-H. If you choose a 3-position switch, then that dual rate instantly becomes a triple rate (see example).

• Stick position (ACRO/GLIDER). (Ex: On rudder you normally use only the center 3/4 of the stick movement except for

extreme maneuvers such as snaps/spins/stalls. As long as your R

UDDER STICK does not exceed 90% of maximum throw,

the rudder responds at your lower rate, allowing small, gentle corrections. When the stick passes 90% (ie. stall turn), the

rudder goes to high rate’s 90%, which is a MUCH higher amount of travel than your low rate at 89%.)

Ex: EPA = 1” Low Rate = 50% High Rate = 100%

At 89% Low Rate = .45”

At 90% High Rate = .9”

[Note] Only if any stick is chosen by the item of "SW1", a switch can also be chosen by the item of "SW2." When

operated simultaneously, the switch operation has priority over the stick operation. (ACRO)

Adjustability:

• Range: 0 - 140% (0 setting would deactivate the control completely.) Initial

value=100%

• Adjustable for each direction(ACRO/GLIDER). (ie. Up/down, left/right) (Ex: Most

models fly upright without any elevator trim, but require some down elevator

when inverted just to maintain level flight. By increasing the down travel by the

amount required to hold the model inverted, the model now has equal travel

available from level upright or level inverted.)

Exponential: changes the response curve of the servos relative to the stick position to make flying more pleasant. You

can make the servo movement less or more sensitive around neutral for rudder, aileron, elevator, and throttle (except HELI

type - use THROTTLE CURVE instead).

Why use expo? Many models require a large amount of travel to perform their best tricks. However, without exponential,

they are “touchy” around neutral, making them unpleasant to fly and making small corrections very difficult. Additionally,

by setting different exponentials for each rate, you can make the effectiveness of small corrections similar in each rate, as

in our example below.

The best way to understand exponential is to try it:

• Having made no changes yet in the D/R,EXP screen, move S

WITCH D to “down” (toward the AILERON STICK).

• Cursor down to EXP and dial to 100%.

• Move S

WITCH D up. Hold the AILERON STICK at 1/4 stick and move SWITCH D down.

• Notice how much less travel there is.

• Go to 3/4 stick and repeat. Notice how the travel is much closer, if not identical.

100

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba 9CAPsuper Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info