Bedienungsanleitung Futaba 9CHFsuper (Seite 104 von 109) (Englisch)

29009

104

Zoom out

Zoom in

Vorherige Seite

1/109

Nächste Seite

GOVERNOR: (HELI) programming which eases the setup of the GV-1 governor. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .95

GV-1: part number/name for Futabaís electronic governor. See Gyros and Governors and GOVERNOR for details.

Gyro, gyroscope: equipment that senses change in direction and provides input to compensate for that change. For

description of aircraft use, see p. 66. For description of types, and helicopter use, see GYRO SENS .

Gyros and Governors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .95

Heading-hold gyro: gyro that specifically measures the unwanted deflection angle and compensates until a corresponding angle

has been returned. See Gyros and Governors.

HELI: model type, rotary wing. See MODELTYPE.

Helicopter radio: transmitter that includes helicopter-friendly switch and control layout and sufficient programming to

at least support a 5-channel helicopter. The 9CA super and 9CH super radios both contain all needed programming.

The 9CH super has a more heli-friendly layout (through switch positioning and no ratchet on throttle for easier hovering)

High band: 72MHz equipment on a channel from 36 to 60. Receiver channel may be changed to any channel within the

high band without needing retuning. Transmittermust not be changed except by certified technician. . . . . . . . . . . . . .8

High Rate: See D/R,EXP.

Hover: to maintain a stationary position relative to a point on the ground.

HOVERING PITCH: see Hovering setups.

HOVERING THROTTLE: see Hovering setups.

Hovering setups: in-flight adjustments to pitch and throttle curves around center THROTTLE STICK position (the ideal

hovering point). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93

Idle management: varying settings and control of the modelís idle. Ex: using IDLE-DOWN to lower engine's idle point for

landings and certain maneuvers; using THR-CUT function to safely and accurately shut the engine off as needed without

requiring constant adjustment of throttle trims. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .33

IDLE-DOWN:: offset mix that slows the engineís idle point (decreasing the amount of travel of the throttle servo when at

low THROTTLE STICK POSITION). Typically used to keep the model sitting still on the runway prior to take off, for slow

aerobatic maneuvers such as spins, and for landings. See Idle management. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .33

IDLE-UP: separate condition created to allow inverted and other types of flight with a helicopter not easily achieved in

the normal condition. Note: the idle-ups are activated by activating their throttle curves. Also note that OFFSET is

available to create separate trims within each condition. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .90

In-flight needle control: see THROTTLE-NEEDLE.

INH: makes a feature inactive/unable to be used. When a function is inhibited, it cannot be used even if the assigned

switch is ON. Turns off functionality without losing any settings. Only visible in specific features.

Inhibit: see INH.

Installation: radio installation and setup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16

Inverted: to fly a model upside-down.

Inverted flight control programming: not available in the 9C. Most modelers no longer use this ìcrutchî to fly inverted,

instead learning to recognize the modelís behaviors when inverted and compensate appropriately.

Kill switch: (1) throttle cut switch to close carburetor (see THR-CUT, p. 33). (2) gasoline ignition engine kill switch

which removes spark to the plugs to stop the engine. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .66

Launch setting: (GLID) see START-OFS.

104

GYRO SENS (ACRO/HELI): gyro sensitivity programming designed to ease the setup and use of gyroscopes on model

airplanes and helicopters. Manual pages include extensive descriptions of gyro types. . . . . . . . . . . . . . . . . . . . . . . . .65, 95

HI/LO-PIT (HELI): may be used to adjust pitch curves high and low side in flight. . . . . . . . . . . . . . . . . . . . . . . . . . . . .94

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba 9CHFsuper Seite 104

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info