Bedienungsanleitung Futaba 9CHPsuper (Seite 16 von 109) (Englisch)

29041

Zoom out

Zoom in

Vorherige Seite

1/109

Nächste Seite

RADIO INSTALLATION

While you are installing the battery, receiver, switch harness and servos into your model’s fuselage, please pay attention to

the following guidelines:

Use the supplied rubber grommets when you mount each servo. Be sure not to

over-tighten the screws. If any portion of the servo case directly contacts the fuselage

or the servo rails, the rubber grommets will not dampen the vibration, which can cause

mechanical wear and servo failure.

Servo Throw

Once you have installed the servos, operate each one over its full travel and check that the pushrod and output

arms do not bind or collide with each other, even at extreme trim settings. Check to see that each control linkage

does not require undue force to move (if you hear a servo buzzing when there is no transmitter control motion, most

likely there is too much friction in the control or pushrod). Even though the servo will tolerate loads, any unnecessary

load applied to the servo arm will drain the battery pack quickly.

Switch Harness Installation

When you are ready to install the switch harness, remove the switch cover and use it as a template to cut screw holes

and a rectangular hole slightly larger than the full stroke of the switch. Choose a switch location on the opposite side

of the fuselage from the engine exhaust pipe, and pick a location where it can’t be inadvertently turned on or off

during handling or storage. Install the switch so it moves without restriction and snaps from ON to OFF and vice

versa.

Receiver Antenna

It is normal for the receiver antenna to be longer than the fuselage.

DO NOT cut or fold it back on itself — cutting or folding changes the electrical length of the antenna and may

reduce range. Secure the antenna to the top of the vertical fin, and let the excess wire length trail behind. You may run

the antenna inside of a non-metallic housing within the fuselage, but range may suffer if the antenna is located near

metal or carbon fiber pushrods or cables. Be sure to perform a range check before flying.

Receiver Notes

When you insert servo, switch or battery connectors into the receiver, note that each plastic housing has an align-

ment tab. Be sure the alignment tab is oriented properly before inserting the connector. To remove a connector from

the receiver, pull on the connector housing rather than the wires.

If your aileron servo (or others) are too far away to plug into the receiver, use an aileron extension cord to extend

the length of the servo lead. Additional Futaba extension cords of varying lengths are available from your hobby dealer.

Always use an extension of the proper length. Avoid plugging multiple extensions together to attain your desired length. If

distance is greater than 18” or multiple or high current draw servos are being used, use Futaba Heavy-Duty servo exten-

sions.

Receiver Vibration and Waterproofing

The receiver contains precision electronic parts. Be sure to avoid vibration, shock, and temperature extremes.

For protection, wrap the receiver in foam rubber or other vibration-absorbing materials. It is also a good idea

to waterproof the receiver by placing it in a plastic bag and securing the open end of the bag with a rubber band before

wrapping it with foam rubber. If you accidentally get moisture or fuel inside the receiver, you may experience inter-

mittent operation or a crash. If in doubt, send the receiver for service.

Wood screw

Rubber grommet

Brass eyelet

Servo moun

or rail

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba 9CHPsuper Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info