Bedienungsanleitung Futaba 9CPsuper (Seite 107 von 109) (Englisch)

29049

107

Zoom out

Zoom in

Vorherige Seite

1/109

Nächste Seite

Rudder-to-throttle mix: (HELI) adds throttle to counter the added load from increasing pitch of the tail blades,

maintaining a constant head-speed with rudder. (This is a minor effect and is not critical in most helicopters.) Not a

preprogrammed mix. See Programmable mix.

Rx: receiver.

SAFE MODE: feature in snap roll programming that does not allow a snap roll if landing gear is lowered. See Snap roll.

Sailplane: glider, non-powered model aircraft type. See GLID / MODEL TYPE.

ELECT (CURSOR) BUTTONS: controls used in various ways during programming. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11

Select a model: see MODEL SELECT.

Service Center. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3

SERVO: bar graph display on screen to show real time movement/commands sent to servos by transmitter in response to

user movements. Also includes a servo test feature. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .42

Servo reversing: see REVERSE.

Servo Slow: see Channel delay.

Servo testing, servo display: See SERVO.

SET: to accept. Usually done by pressing and holding the dial when instructed.

Slave: channel that moves in response to the command of the master. See Programmable mix.

Slaving servos: see programmable mix, p. 60.

Slider assignability: sliders on side of radio, known as VR(D) and VR(E) in programming, may be assigned to control

channels 5-8 in AUX-CH, used as the primary control of a mix in programmable mixes, etc.

Slow: see Channel delay.

Smoke system: injects a specialized smoke oil into the hot exhaust to create air-show like smoke trails. . . . . . . . . . . .66

SNAP ROLL: (ACRO) combines rudder, elevator and aileron movement to cause the aircraft to snap or spin at the flip of a

switch. 9C super of fers 4 separate snaps with 1 or 2 switches used for selection. . . . . . . . . . . . . . . . . . . . . . . . . . . . .52

Speed Flaps: main flaps on a 5-servo glider.

SPEED OFS (GLID): speed run offset programming. Offsets aileron/elevator/rudder settings to provide minimum drag for

high speed flight. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .74

START OFS (GLID): start offset programming. Offsets aileron/elevator/rudder settings to provide for maximum lift during launch. . . . . .73

Stick adjustments: change stick tension and height. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15

STk-THR: assigned to T

HROTTLESTICK. See AIRBRAKE for example.

SUB-TRIM: used to fine tune the center or neutral point of each servo. Allows full trim function from the trim sliders for

flight trimming. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .42

SWASH AFR: (HELI, CCPM types only) adjustment of the travel of all servos involved in the particular controlís

movement only during the movement of that control. Ex: reverse the direction of movement of collective pitch while

not affecting the direction of movement of either cyclic control. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .84

Swashplate type: (HELI). Part of the model type selection process. Selects specific heli swashplate geometry, such as one

of four available types of "CCPM." . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .82

Switch programmability: MOST features are reassignable to a variety of switches, including simply moving an auxiliary

control such as flaps from the stock dial to a switch or other location. See AUX-CH.

Synthesized module/receiver: The 9C super's compatible with the R309DPS Futaba synthesized receiver that can be used

on any 72MHz channel. There is not a synthesized transmitter module that is safe/FCC certified/approved for use with the

9C super at the time of this printing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10

107

SWASH-THR (HELI): is corrected the tendency of the model to change altitude when the rotor is tilted by aileron,

elevator, and other controls. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .85

SW/MODE (GLID): is used to switch settings, etc. for OFFSET, BUTTERFLY, and other functions . . .. . . . . . . . .75, 76, 77

SW SELECT (ACRO/HELI): is used for switch assignment for AIRBRAKE, THR-HOLD, and other functions . . . 56, 77, 88, 90

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba 9CPsuper Seite 107

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info