Bedienungsanleitung Futaba CONQUEST (Seite 3 von 6) (Englisch)

29057

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

Elevator dual rate switch (6NLK only)

This switch turns the elevator dual rate function on and

off. The lower position is dual rate OFF and the upper

position is dual rate ON.

Elevator dual rate trimmer (6NLK only)

This trimmer sets the elevator deflection angle when the

elevator dual rate switch is in the ON position. It has the

same functions as aileron dual rate.

Power switch

The upper position is ON.

Level meter

This level meter indicates the transmitter battery voltage.

Neck strap bracket

Bracket for the neck strap (optional).

Antenna

Strong telescoping antenna. Extend it to its full length

when using the transmitter.

Handle

Use this bar to carry the transmitter.

Nonslip adjustable lever head

The length of the lever head can be adjusted to fit the

operator.

Adjust to the length of your hand.

Lever head

in the arrow direction, and adjust the head to

the most comfortable length, then lock it by

turning it in the direction opposite the arrows.

Fig.

Charging jack

Battery charge jack for built-in NiCad battery.

•CHARGING OF

TRANSMITTER

AND RECEIVER

NI-CAD BATTERIES:

Recharge the receiver and

transmitter NiCad batteries

as shown in Fig. 5.

Notes:

1) First, connect to TX NiCad

and red lamp goes on.

2) Then connect to RX NiCad

after connecting, L, E D,

changes color from red to

greenish red (orange) which

indicates that both TX and

RX NiCads are being charged.

3) In case of separate charging

L, E, D, color will be;

RX NiCad - Green.

TX NiCad - Red.

Fig. 5

•Connect the charging plug of the FBC-8B charge to the

transmitter charging jack, connect the 3P connector of

the FBC-8B to the receiver NiCad battery (NR-4M), and

plug the FBC-8B to a 117VAC outlet as shown in this figure.

•The Receiver battery can be used about 10 times at 10

minutes per flight between rechargings.

•Charge the batteries for about 15 hours. When the set is not

in use for some time, repeat discharge and charge two to

three times before use. (If the batteries are not used for a

long time, their capacity will go down).

•FBC-8B charges transmitter and receiver NiCad batteries in-

dependently or simultaneously.

Battery cover

Remove this cover

when switching the

servo reversing

switches.

Servo reversing switches

Using the servo reversing switches

• The left side of each switch is the normal position.

• The servo reversing switches reverse the direction of opera-

tion of the servos.

Elevator servo

reversing switch

Aileron servo

reversing switch

Throttle servo

reversing switch

Rudder servo

reversing switch

Fig.

Landing

gear ser

reversing

switch.

(6NLK ONLY)

NORM —Normal

REV —Reverse

After linkage is complete, inspect the servos. If the direction of

operation of the stick lever and the direction of operation of a

servo are opposite, switch the appropriate servo reversing switch.

24 Transmitter NiCad battery NT-8LP

The tension of the stick lever spring can be adjusted.

When adjusting the

aileron, and elevator

the inside module

is removed.

Use a small Phillips

screwdriver.

When the dual rate switch is ON, the servo throw can be adjusted

within this ranqe with the dual rate trimmer.

Fig.

Lever head

Unlock lever heads

and

, by turning them

Elevator

Aileron

Fig.

Rudder

When these screws are

removed, the back cover

can be removed.

• The tension of the

spring can be ad

justed by removing

the transmitter

back cover and

turning the screw

for each stick. Set

the springs for the

best stick feel.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba CONQUEST Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info