Bedienungsanleitung Futaba FP2GS (Seite 1 von 4) (Englisch)

30066

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

Futaba

DIGITAL PROPORTIONAL

RADIO CONTROL

FP-2GS

D60431

SPECIAL FEATURES:

SET CONTENTS AND RATINGS

(Specifications are subject to change without prior notice.)

TRANSMITTER FP-T2GS

• Contemporary

styling with smooth operating gimbals for

superior control.

• 500mW output.

• Battery level

meter indicates the state of the battery

voltage at a glance.

• Built-in antenna.

RECEIVER FP-R102GF

•BEC (Battery Eliminator Circuitry) system allows sharing

of the running Nicd battery and eliminates the need

for a

regulator and diode.

•High performance 2 channel receiver with ASP system

when used with the proper transmitter.

•Crystal

socket

uses

new

type

of highly reliable subminia-

ture pins. Reliability is increased and the crystal can be

changed from the outside.

SERVO FP-S128

SMALL, RUGGED. HIGH NEUTRAL SERVO

•Skew type armature motor.

Movement of the trimmer by even one notch is tracked by

a skew type motor which displays a performance near that

of a

coreless motor.

•New indirect drive potentiometer improves vibration and

shock resistance and neutral accuracy.

•Futaba low-power custom 1C provides extremely high

torque, narrow dead band, and superior tracking.

•Fiberglass reinforced PBT (polybutylene terephthalate)

injection

molded

servo

case

mechanically strong and

invulnerable to glow fuel.

•Strong

polyacetal

resin

ultra-precision

servo

gear

features

smooth operation, positive neutral, and very little backlash.

•Fiberglass reinforced epoxy resin PC board with thru-the-

hole plating improves servo amp vibration and shock resist-

ance.

•Three pin connector eliminates faulty contact and improves

reliability against vibration and shock. Housing has a

reverse insertion prevention mechanism.

•Special grommet simplifies

mounting of the servo and has

an excellent cushioning effect.

•Six special adjustable splined horns.

•High 48.7 oz.in

(3.5kg-cm) maximum output torque allows

use

in almost any model.

Model number

Transmitter

Receiver

Servo

Switch, battery holder, etc.

FP-2GS

FP-T2GSx1

FP-R102GFx1

FP.S128.x2

TRANSMITTER FP-T2GS.

Operating method 2 stick system

Transmitting frequency 27MHz band, 72MHz band

Modulation system AM (amplitude modulation)

Power requirement

12V,

round penlight battery x 8

Receiver FP-R102GF

Receiving frequency

27MHz band, bands 1 to 6

72,75MHz

455kHz

3kHz/-3dB

550 yards (500m) on the ground

when used with FP-T2GS (At the

best radio wave condition of envi-

ronment)

4.8V

8.4V

7.2V/13mA,4.8V/33mA

1.46x

2.19

0.75

(37

55.5

19mm)

1.34

(38g)

Intermediate frequency

Selectivity

Receiving range

Power supply

Current drain

Dimensions

Weight

SERVO FP-S128

Control system

Operating angle

Power requirement

Current drain (IDLE)

Output torque

Operating speed

Dimensions

+pulse width control

One side 45° or more

4.8V-6V

6.0V, 8mA (at idle)

48.7 oz.in. (3.5 kg-cm)

0.24 sec/60°

1.6x0.8x 1.6 in.

(40.5 x 20 x 40.5mm)

1.92oz. (53g)

Weight

HANDLING THE TRANSMITTER

•The name of each part of the transmitter is given in the figure.

Familiarize yourself with their operation.

•Remove the battery cover on the rear of the transmitter as

illustrated in the figure, and insert 8 round penlight batteries,

paying careful attention to their polarity.

•Extend the antenna fully, and set the power switch to the

ON position. The pointer of the level meter should deflect to

the green zone. If it fails to deflect, or deflects slowly, the

polarity of the batteries is incorrect, or the batteries are

faulty.

•Since the range of the radio waves will become short when

the pointer of the level meter deflects to the red zone, re-

place the batteries when the pointer only deflects to the

boundary between the green and red zones.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba FP2GS Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info