Order Numbers
F4090 - F4091 - F4092
F4095 - F4096 - F4097
There are two alternatives for installing controls in the inner
option wells:
1. Cut a hole in the aluminium panel at the switch symbol position,
using a hand-held 6 mm Ø drill bit,or
2. Use a ready-made die-cut panel, which is available under
No.F 1589.The set includes 12 rubber plugs which are used to
seal any openings which are not used,e.g.after re-positioning
switches.
In all other respects the switches are installed and secured exactly
as described previously in this section.
Here again there are two alternative methods of installation:
1. Cut two holes in the aluminium panel at the switch symbol
position,using a hand-held 6 mm Ø drill bit,or
2. Use a ready-made die-cut panel, which is available under
No.F 1589.The set includes 12 rubber plugs which are used to
seal any openings which are not used,e.g.after re-positioning
switches.
Each mix trimmer module takes up three inner option wells.A maxi-
mum of two modules can be installed:one right,one left.
- Drill holes in switch well positions 1 and 3.
- Fit the module from the rear with the connecting lead termina-
ting in the 2-pin plug at the top,pointing towards the aerial.
- Fix the module to the transmitter using the screws supplied (see
arrow).
- Push the trimmer knobs onto the pot shafts.
- Ensure that the index line on the knob lines up with that on the
pot shaft.
- Secure the trimmer knob with a 1.5 mm allen key.
Take care to arrange the cables neatly!
- To install the front linear sliders,press the blind cover out from
the rear of the transmitter using a screwdriver.
- Carefully install the slider with the cable pointing down
(towards the battery).
- Route the cable under the main circuit board and connect the
slider.
The circuit board is mounted on stand-off pillars to provide space
for the cables.
Do not run the cables over the circuit board,otherwise they will
be jammed between the circuit board and the back panel.
- Carefully fix the slider in place from the front using the screws
supplied.
- Peel off the protective film and apply the self-adhesive scale
label.
- Carefully push the knob onto the slider shaft.
- Check that the slider works smoothly,then re-attach the back
panel.
- Carefully push out the rear blind cover of the slider slot from the
inside of the transmitter using a screwdriver.
- Install the slider from the rear,with the cable pointing up,
towards the latch.
- Carefully fit the retaining screws from the outside to secure the
unit.
- Each linear slider is supplied complete with one left-hand and
one right-hand knob.
- Select the appropriate knob to suit the side of the transmitter,
and push it onto the slider shaft.
- Check that the slider works smoothly,then re-attach the back
panel.
9
Installing mix trimmers (F 1506) in the inner option wells
Installing the front linear sliders
Installing the rear linear sliders
