Bedienungsanleitung Futaba SG14 (Seite 46 von 169) (Englisch)

531803

Zoom out

Zoom in

Vorherige Seite

1/169

Nächste Seite

throttle stick in the 1/3 or less (slow side) position.

5. Idle down setting (Airplane)

The idling speed can be lowered with one touch

by a switch without changing the throttle trim

position. Perform this setting with the Idle Down

function of the Linkage Menu. After activating the

Idle Down function and selecting the switch, adjust

the idle down speed. For safety, the idle down

function acts only when the throttle stick is in the

lowest part of its throw.

*While the Throttle Cut function is in operation, the Idle

Down function does not work.

6. D/R function

D/R function is used to adjust the throw and

operation curve of the stick functions (aileron,

elevator, rudder and throttle) for each switch





the maximum throw directions in the End Point

settings.

(Airplane)

(Glider)

7. Airbrake (Airplane)

This function is used when an airbrake is

necessary when taking off or diving, etc. Please

note: this menu item is only available under certain



if a single aileron wing type has been selected.



be activated by a switch.

The offset amount of the aileron, elevator, and

flap servos can be adjusted as needed. Also the



be adjusted. You can also set the Auto Mode, which

will link Airbrake to a stick, switch, or dial. A

separate stick switch or dial can also be set as the

ON/OFF switch.



The Condition Select function automatically

allocates the normal condition (NORMAL) for

each model. NORMAL is the default condition and

is the only one active when a new model type is





to a description of the CONDITION function.

*The NORMAL is always on, and remains on until other

conditions are activated by switches, stick positions, etc.

Please refer to the section entitled Switch Selection Method

for additional information on how to do so.

*It is possible to customize the activation of the flight

conditions.

*The Condition Delay can be programmed for each channel.

The Condition Delay is used to change the servo throw

smoothly when switching conditions.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba SG14 Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info