Bedienungsanleitung Futaba T-32MZ (Seite 50 von 189) (Englisch)

747980

Zoom out

Zoom in

Vorherige Seite

1/189

Nächste Seite

＜

Model Basic Setting Procedure

＞

&RQÀUPWKDWWKHUDWHRIWKHVORZHVWSRVLWLRQRI

WKHVWLFNLVLQLWLDOVHWWLQJ

%HVXUHWKDWZKHQVHWWRKLJKVLGHWKHFXUYH

RIDQ\FRQGLWLRQGRHVQRWH[FHHG

([DPSOHRISLWFKFXUYHVHWWLQJ

&DOOWKHSLWFKFXUYHRIHDFKFRQGLWLRQZLWKWKH

condition select switch.

*Pitch curve graph display can be switched to pitch angle

direct reading display.

$3LWFKFXUYH1RUPDO

Make the pitch at hovering approximately +5

Set the pitch at hovering with the stick position at

WKHSRLQWDVWKHVWDQGDUG

*Stability at hovering may be connected to the throttle curve.

Adjustment is easy by using the hovering throttle function

and hovering pitch function together.

%3LWFKFXUYH,GOHXS

7KHLGOHXSSLWFKFXUYHIXQFWLRQFUHDWHVDFXUYH

PDWFKHGWRDLUERUQHÁLJKW

6HWWR

a

as standard.

&3LWFKFXUYH,GOHXS

7KHKLJKVLGHSLWFKVHWWLQJLVOHVVWKDQLGOHXS

The standard is +8

'3LWFKFXUYH+ROG

$WDXWRURWDWLRQXVHWKHPD[LPXPSLWFKDWERWK

the high and low sides.

[Pitch angle setting example]

7KURWWOHKROG

a

6. Throttle hold setting

Call the Throttle Hold function from the Model Menu and

switch to the throttle hold condition with the condition select

switch.

Note: $WLQLWLDOVHWWLQJWKHVHWWLQJPRGHLVWKH

group mode. Since this function is not used at other

conditions, switch to the single mode before setting.

ŏ6HWWLQJWRWKHVWDWHZKLFKDFWLYDWHVWKHIXQFWLRQ

The throttle hold function allows setting for throttle

FXWDQGVZLWFKLQJRIWKHIXQFWLRQÀ[HGDWWKHLGOH

position by switch for training. Either one or both

functions can be performed.

ŏ+ROGSRVLWLRQVHWWLQJ

This function sets the servo operation position at

throttle hold. (Throttle cut and idle positions)

ŏ2WKHUVHWWLQJV

:KHQ\RXZDQWWROLQNRSHUDWLRQZLWKVWLFN

PDQLSXODWLRQWKH$XWRPRGHFDQEHVHW

:KHQ\RXZDQWWRDGMXVWWKHVHUYRVSHHGDGMXVW

[Speed].

3LWFKWR58'PL[LQJVHWWLQJ

Use this function when you want to suppress the torque

generated by the changes in the pitch and speed of the main

rotor during pitch operation. Adjust it so that the nose does not

swing in the rudder direction. However, when using a heading

hold gyro like those shown below, do not use Pitch to RUD

mixing.

Note:KHQXVLQJD)XWDED*<VHULHVJ\URRURWKHU

KHDGLQJKROGJ\URWKLV3LWFKWR58'PL[LQJVKRXOG

not be used. The reaction torque is corrected at

WKHJ\URVLGH:KHQRSHUDWLQJWKHJ\URLQWKH$9&6

mode, the mixed signal will cause neutral deviation

symptoms and the gyro will not operate normally.

Call the Pitch to RUD mixing function from the Model

Menu, and set the curve for each condition. (At initial setting,

this function is in the "INH" state. To use it, set it to the "ON"

state.)

(17 points curve)

Curve setting of up to 17 points is possible. However, in the

following setting example, a simple curve can be adjusted by

using the [Linear] curve type.

Note:$WLQLWLDOVHWWLQJWKHVHWWLQJPRGHLVWKHJURXS

PRGH,QWKLVPRGHWKHVDPHFRQWHQWVDUHVHWDWLQ

DOOFRQGLWLRQV:KHQ\RXZDQWWRVHWWKHVHOHFWHG

condition only, switch to the single mode.

6HWWLQJH[DPSOH!

Call the mixing curve of each condition with the condition

select switch.

+(/,&237(5

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba T-32MZ Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Futaba T-32MZ

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info