Bedienungsanleitung Futaba T10 CAG (Seite 50 von 119) (Englisch)

450995

Zoom out

Zoom in

Vorherige Seite

1/119

Nächste Seite

FailSafe (loss of clean signal and low receiver battery) submenu (

F/S

): sets responses in case of loss of signal or low Rx

battery.

FailSafe (

F/S

): instructs a 2.4G receiver what to do in the event radio interference is received.

Adjustability:

• Each channel may be set independently. (

2.4G-7CH

mode: ch3 only)

• The

NOR

(normal) setting holds the servo in its last commanded position.

• The

F/S

(FailSafe) function moves each servo to a predetermined position.

• NOTE: the setting of the throttle's

F/S

also applies to the Battery

F/S

(see

below).

Examples:

• The

F/S

setting is used in certain competitions to prevent the aircraft from flying away and doing potential damage

elsewhere. Conversely, the

F/S

VHWWLQJPD\DOVREHXVHGWRJRWRQHXWUDORQDOOVHUYRVKRSHIXOO\NHHSLQJWKHSODQHÀ\LQJ

long enough to regain control.

• Competition modelers often maintain the

NOR

function so that brief interference will not affect their model's maneuver.

• Set the throttle channel so that the engine idles when there is interference (

ACRO

7KLVPD\JLYHHQRXJKWLPHWRÀ\DZD\

from and recover from the radio interference and minimize damage if crashed.

• For helicopters,

NOR

is typically the safest choice.

•

We also recommend setting a gasoline engine's electronic kill switch to the OFF position in the

F/S

function for safety reasons.

Updating

F/S

Settings: If you specify a

F/S

setting, the FailSafe data is automatically transmitted. When you choose the

F/S

mode, check that your settings are as desired by turning off the transmitter power switch and verifying that the servos

move to the settings that you chose.

GOAL of EXAMPLE: STEPS: INPUTS:

Change the receiver FailSafe command

for channel 8 (gasoline engine kill

switch) to a preset position.

NOTE: This is one of several

functions for which the radio requires

FRQ¿UPDWLRQWRPDNHDFKDQJH

Open the

BASIC

menu, then open

F/S

function.

for 1 second.

(If

ADVANCE

, again.)

F/S

Choose Channel to change. (ex: Ch. 8)

to Ch 8.

Set and FRQ¿UP fail safe command.

that controls channel 8 to desired

OFF

position.

for 1 second to store.

Repeat as desired.

Close.

Where next? Read below for information on Battery FailSafe.

Adjust

END POINTs

to gain proper

F/S

responses if needed: see p. 39.

Adjust

SUB-TRIM

to gain proper

F/S

responses if needed: see p. 49.

Battery FailSafe (

F/S

): a second battery low warning feature (separate from the transmitter low voltage warning). When

the airborne battery voltage drops below approximately 3.8V, the 2.4G receiver’s battery

F/S

function moves the throttle

to a predetermined position. When the Battery

F/S

function is activated, your engine will move to idle (if you haven't set a

position) or a preset position. You should immediately land. You may temporarily reset the Battery

F/S

function by moving

the THROTTLE STICK to idle. You will have about 30 seconds of throttle control before the battery function reactivates.

Adjustability:

•

NOR F/S

setting for throttle results in Battery

F/S

going to the servo position reached by moving THROTTLE STICK to

the bottom with TRIM LEVER centered;

•

F/S

position setting for throttle results in Battery

F/S

also going to the same throttle servo position as the regular

F/S

If using a 6V (5-cell) receiver battery, it is very likely that your battery will be rapidly running out of charge before

battery FailSafe takes over. It is not a good idea to count on battery FailSafe to protect your model at any time. This is

especially true when using a 5-cell battery.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba T10 CAG Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info