Bedienungsanleitung Futaba T6J - 2.4GHz (Seite 17 von 94) (Englisch)

566460

Zoom out

Zoom in

Vorherige Seite

1/94

Nächste Seite





          



causing a crash. To erase any potential memory, cycle the NiCd batteries by discharging, then charging

                 

transmitter sticks until the servos are moving very slowly, indicating that the battery is discharged. Cycling

should be done every one to two months, even during the winter or periods of long storage. If using a

cycler with a readout, note the capacity after the batteries have been cycled. If there is a noticeable drop in

capacity the batteries should be replaced.

Note: Charging your batteries with a Futaba A/C battery charger is always safe. However, fast charging with

an aftermarket charger is acceptable as long as you know how to properly operate the charger. Never charge

at a rate higher than suggested by the manufacturer. If not done correctly, fast charging can damage the

batteries.

Battery Care and Precautions



and/or receiver battery packs. These are included to serve only as general guidelines, and are not intended

to replace or supersede the information provided by the battery and/or charger manufacturer. For complete

information, please refer to the instructions that are included with the battery pack(s) and/or chargers that

accompany the products purchased.

 Do not allow children to charge battery packs without adult supervision.

 Do not charge battery packs that have been damaged in any way. We strongly suggest frequent inspection

of the battery packs to ensure that no damage has occurred.

 

and allow to cool.

 

 Do not deep cycle NiMH batteries as permanent damage could result.

 Never charge batteries on a surface that may become hot, or may be impacted by the heat.

 Immediately end the charging procedure if either the batteries or charger itself become overly hot.

            

packs with some voltage remaining on the cells (refer to battery supplier).

 NiMH cells have a self-discharge rate of approximately 20-25% (compared to 15% for NiCd batteries). It is

important to recharge NiMH batteries immediately prior to use.

 Never connect the battery in reverse. Reverse connection will cause the battery to overheat or will damage

the inside of the charger.

 Do not add an additional charge after charging.

 Never charge with a current exceeding the nominal capacity (lC) of the rechargeable battery.

 If a battery is charged with a current exceeding 1C, the battery will overheat and deteriorate.

 Do not connect two battery packs or more to one output terminal.

 Avoid extremely cold and hot places and the direct sunlight when you charge batteries.

 It is recommended to perform charging within the 10 ~ 30°C (50-85°F) range. Otherwise, it may cause

abnormal charging and overheat.

Futaba T6J - 2.4GHz Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info