Bedienungsanleitung Futaba T6J - 2.4GHz (Seite 28 von 94) (Englisch)

566460

Zoom out

Zoom in

Vorherige Seite

1/94

Nächste Seite

Dual Rates/Exponential Settings-

Dual Rates/Exponential Settings vary slightly between the airplane (ACRO) mode and the helicopter (HELI)

mode. As such, the information pertaining to these functions will be separated into ACRO and HELI

sections below. Please adhere to the section that pertains to the model for which you are programming the

T6J transmitter.

ACRO Dual Rates/Exponential Information:

Dual Rates (ACRO):



affecting the overall travel of the servo(s). Thus, decreasing the percentage value for a given servo will

reduce the travel amount of the channel respectively.

For example, if the elevator of the aircraft travels 1/2” at the high rate and maximum stick input, and a value

of 50% is input for the low rate, when the switch is moved to the low rate position, the servo moves exactly

half as far per stick position. Following this example, if the elevator control input is all the way up, the

maximum travel is now 1/4”

The T6J transmitter offers dual rates on the aileron, elevator and rudder channels. The dual rates are

assignable to any of the switches on the transmitter and all are simultaneously activated by the dual rate

switch selected.

The amount of travel decrease for each control may be set between 0% and 140% of the values set for the

end points (explained in End Point Adjustment on page 33).

Note: It is possible to set a dual rate value to zero, thus causing no response from that channel when the dual

rates are activated. If the dual rates are inadvertently set to zero, a crash could result.

Note:



D/R Dual Rate Settings (ACRO)

To select the Switch/position to control the dual rates:

Prior to programming the dual rates for the aileron, elevator or rudder channels, we suggest selection of the

switch that will be utilized to control the rate settings.

1) Turn the transmitter on.

2) Press and hold the MODE button to access the programming mode.

3) Press either the MODE key OR the END key to scroll through the function menus. Each time one of the

aforementioned keys is pressed the menu will change accordingly. Continue pressing the MODE or END

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba T6J - 2.4GHz Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info