Bedienungsanleitung Futaba T6J - 2.4GHz (Seite 48 von 94) (Englisch)

566460

Zoom out

Zoom in

Vorherige Seite

1/94

Nächste Seite

3) Press either the MODE key OR the END key to scroll through the function menus.

Continue pressing the MODE or END key until the normal throttle curve (N-TH)

menu appears on screen.

4) The LCD screen will contain the throttle curve point indication (left side of screen),

as well as the current throttle curve value, expressed as a percentage of travel, on the right side of the

display.

Note: Point 1 is shown initially which is throttle stick all the way downward (slow) position. Point 5 is

throttle stick all the way upward (hi) position.

Press the DATA INPUT lever upward to increase the percentage of servo travel for the respective point on

the throttle curve. Press the DATA INPUT lever downward to decrease the percentage of servo travel for

the respective point on the throttle curve.

5) Press the SELECT button one time to bring up the point two (2) throttle curve adjustments. Again, use the

DATA INPUT lever to adjust the values accordingly.

6) Repeat the previous steps to set the normal throttle curve point values for the remaining three (3) points.

7) Press and hold the END button to exit the programming mode.

Normal pitch curve (N-PI)-(HELI only)-





This curve is utilized to best match the blade collective pitch to the engine RPM for consistent load on the

engine. Pitch curve can be adjusted from 0-100% each point. This normal pitch curve creates a basic curve

for hovering. Use this function together with the normal throttle curve to obtain the performance you desire.

While each helicopter manufacturer will have specific recommendations for your flying style, generally

speaking, the points should be adjusted as follows:

 Point 1- the collective servo is at the desired lowest point with the throttle stick at the lowest (bottom)

position.

 Point 2- the collective servo is at the desired point with the throttle stick is advanced ¼ of the way.

 Point 3- the collective servo is at the desired point with the throttle stick advanced ½ way.

 Point 4- the collective servo is at the desired point with the throttle stick advanced ¾ of the way.

 Point 5- the collective servo is at the desired point with the throttle servo fully advanced.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba T6J - 2.4GHz Seite 48

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info