Bedienungsanleitung Futaba T6J - 2.4GHz (Seite 51 von 94) (Englisch)

566460

Zoom out

Zoom in

Vorherige Seite

1/94

Nächste Seite

Note: As with all switch selection availability, if the modeler has programmed any other functionality to this

switch selection, the idle up throttle curve and the other function will be activated simultaneously. As such, it

is imperative to ensure that these desired functions will not negatively impact one another.

For example, if the modeler has programmed Switch B to activate the low rates, and then selected Switch B

as the activation switch for the idle up curves, moving Switch B will activate both functions simultaneously.

Note: if the trainer function is activated, the switch C is allocated for the trainer function automatically.

9) Press and hold the END button to exit the programming mode.

Pitch Curve Idle UP (I-PI) - (HELI only)









A 5-point pitch curve is utilized to best match the blade collective pitch to the engine RPM for consistent

load on the engine. The curve can be adjusted from 0-100% each point. Idle up creates a curve typically



even when the stick is pulled all the way back. This is one of the functions that makes the maneuvers such as







 Point 1- the collective servo is at the desired lowest point with the throttle stick at the lowest (bottom)

position. This is normally full negative pitch.

 Point 2- the collective servo is at the desired point with the throttle stick is advanced ¼ of the way.

 Point 3- the collective servo is at the desired point with the throttle stick advanced ½ way.

 Point 4- the collective servo is at the desired point with the throttle stick advanced ¾ of the way.

 Point 5- the collective servo is at the desired point with the throttle stick fully advanced. This is full positive

pitch.

To set the idle up pitch curve:

1) Turn the transmitter on.

2) Press and hold the MODE button to access the programming mode. An audible

double beep will be heard and the default screen will change accordingly.

3) Press either the MODE key OR the END key to scroll through the function menus.

Continue pressing the MODE or END key until the idle up pitch curve (I-PI) menu

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba T6J - 2.4GHz Seite 51

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info