Bedienungsanleitung Futaba T6J - 2.4GHz (Seite 82 von 94) (Englisch)

566460

Zoom out

Zoom in

Vorherige Seite

1/94

Nächste Seite

 Gain

Gyro sensitivity. When too low, the tail will not hold position well. When too high, the surface being

dampened by the gyro will tend to wag, or hunt for center.

 Glitch

Momentary radio problem that never happens unless you are over trees or a swamp.

 Glow Plug

The heat source for igniting the fuel/air mixture in the engine. When starting the engine a battery is used to





 Grease-in

A very smooth, gentle landing without a hint of a bounce.

 Gyro

A gyro is an electro-mechanical, or electronic device which aids in the control of an R/C model.

The gyro senses motion in one axis, and directs the servo to counter that motion. The sensor, which

can be a mechanical gyroscope, or an electronic piezo crystal, detects unwanted movement. The

gyro then instructs the servo to counter for that motion. At all times, the radio commands will

override the gyro command. The level of control the gyro had is adjusted by the GAIN setting.



Piezo Gyro: uses a piezo crystal to sense movement.

Non-Heading-hold vs. heading hold: A standard (nonHH) gyro senses movement and makes an effort

to counter that movement as long as it feels it. Therefore, it is NOT going to return the model to the

exact heading prior to the movement. Heading Hold (or AVCS) gyros will lock the model into one

position, and accurately correct for movement by sensing rate of change and returning at that same rate.

SMM technology: utilizes a microchip to sense movement and provide all readings. Experiences minimal

      

mechanical gyros.

 Gyro sensitivity

Used to create stick priority or activate each rate of a dual rate gyro based on stick position. This

preprogrammed mix decreases the gain of the gyro directly proportional to the amount of rudder stick given

(or steps the gyro down from high to low rate on dual rate gyros.)

 Heading Hold

This describes a type of Gyro which senses rotation, and maintains direction. This is accomplished by

sensing the rate of motion, and the time of motion, then compensating for the distance. While this sounds

complicated, the effect is that if you have the model dialed in, and point the nose north, with a heading hold

gyro on the yaw axis the model will continue to face north until you command it to yaw. See also Heading



command to turn the model. Often used for ground use only for perfect take off and landing runs.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba T6J - 2.4GHz Seite 82

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info