GOAL of EXAMPLE: STEPS: INPUTS:
67
Adjust travels as needed to match
model’s recommended throws (usually
listed as high rates).
P. 32.
Set up dual/triple rates and exponential
(D/R,EXP)
P. 35.
(Note that in the middle of the left side
of the screen is the name of the channel
and the SWITCH position you are
adjusting. Two or even three rates may
be set per channel by simply choosing
the desired S
WITCH
and programming
percentages with the SWITCH in each of
its 2/3 positions.)
Move flap control from the VR(A) dial
to the left slider [VR(D)]. (AUX-CH)
p. 39.
Where next?
In the BASIC menu, choose END POINT.
Adjust the servos’ end points.
(Ex: flap servo)
Close the function.
Choose D/R,EXP.
Choose the desired control, and set
the first (Ex: high) rate throws and
exponential.
Set the second (low) rate throws and
exponential.
Optional: change dual rate S
WITCH
assignment. Ex: elevator to SWITCH G
with 3 positions.
In the BASIC menu, open AUX-CH.
Choose CH6 (flap).
Change primary control to VR(D).
Change other channels as needed.
Return to the home screen.
2 steps to END POINT.
to choose END POINT.
to FLAP.
VR(A) until travel as desired.
VR(A). Repeat as needed.
to D/R,EXP.
to choose D/R,EXP.
to CH>.
to choose CH>2 (elevator).
A to up position.
[Note screen reads ELEV (UP)]
to D/R.
ELEVATOR STICK. to set.
E
LEVATOR
STICK
. to set.
(Normally the same for both directions.)
to EXP.
ELEVATOR STICK. to set.
ELEVATOR STICK. to set.
to D/R. A to down position.
Repeat above to set low rate.
to SW. to G. G to
center position.
Repeat steps above to set 3rd rate.
to AUX-CH. to choose AUX-CH.
to CH6.
to VR(D).
Repeat as required.
(Other functions you may wish to set up for your model.)
TRAINER p. 40.
Multiple wing or tail servos. See wing types and tail types: p. 44, 48.
START and SPEED OFFSETS, BUTTERFLY (AIRBRAKE/crow), and other
programmable mixes p. 53.
Retractable Gear, Smoke systems, kill switches, and other auxiliary channel
setups: p. 39.
Adjusting SUB-TRIMs to match servo centers: p. 41.
