Originalbetriebsanleitung FUXTEC FX-EB152/FX-EB162_de_en_fr_ita_rev16
45
Note
Only when the device is warm enough does the drill start. Let the engine run
warm enough. Avoid full-throttle shocks during the warm-up phase and let
the device warm up slowly.
NOTE: If the engine does not start after repeated attempts, refer to Troubleshooting.
NOTE: Always pull the starter rope straight out. Pulling the starter at an angle causes
the rope to rub against the eyelet. The diagonal pull can lead to fraying or breaking of
the starter cable. Always hold the starter handle firmly when the rope retracts. Never
allow the rope to be thrown back from the extended position. This could damage the
starter device.
10. Warm start of the device
1. Place the device on a firm and flat surface.
2. Move the engine stop switch to the start position "1".
3. Slide the choke to the "WARM START" position.
4. Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous, high-speed train will provide a strong spark and start
the engine.
If the emgine does not start, please proceed again according to "Cold starting the
device."
11. Stopping the device
Unlock the gas handle. Let the engine return to idle. Push the engine stop switch on the
handle upwards until the device stops. If this does not stop, pull the spark plug
connector in an emergency. Never leave the device unattended while it is running.
