After every use
Clean the air filter
◼ Loosen and remove the filter screw.
◼ Take out the filter.
◼ Prise open the two-part filter with a screw-
driver.
◼ Blow out the inside of both filter parts with
compressed air.
◼ Check the rubber seal and renew if neces-
sary.
◼ Press the filter parts together until they en-
gage audibly, insert the filter in the housing
and secure firmly with the filter screw.
◼ Fit the filter cover again and secure with
the quick-fit clips.
Oil supply hole
◼ Remove the guide rail.
◼ Clean the oil supply hole (N) by suitable
means. Blow through outwards via the oil
filter with compressed air if necessary.
Guide rail oil inlet and oil outlet hole
The guide rail is removed:
◼ Blow out the chain guide groove and front
gear ring (Q) with compressed air.
◼ Clean stubborn dirt from the chain guide
groove with a rail hook (available from
specialist dealer).
◼ Blow out oil inlet hole (O) and oil outlet
hole (P) of the guide rail with compressed air.
Make sure that no filter fibres or dust get
into the suction pipe.
The oil for lubrication of the front gear ring (Q)
and saw chain is supplied from the oil pump
of the chainsaw.
Visual checks
Check the chainsaw for:
− fuel leaks
− loosen attachment parts (particularly guide
rail and saw chain)
− damaged components (handles etc.)
Rectify defects before using the equipment
again.
Periodic maintenance
Fuel filter
