Originalbetriebsanleitung FUXTEC Benzin-Laubbläser/-sauger FX-LBS126P_de_en_fr_ita_rev11
40
32. Start/Stop the leaf blower
The device must not be put into operation until you have read this operating manual,
observed all the manual given and the device has been completely and correctly
installed!
• Only start the device when it is completely assembled.
• Support the device on the ground for starting and hold it firmly.
1. Maintain a distance from flammable materials.
2. Take a safe stand.
3. Place the device on the ground in front of you
4. Hold the device by the upper bracket with your left hand.
5. Grasp the pull starter with your right hand
Starting with cold engine
1. Slide the ON / OFF switch 2 to position 1.
2. Gently press the primer pump 4B below the choke lever 4A several times until fuel enters the
pump.
3. Slide the choke lever 4A to
4. You can pull the throttle lock lever 12 to the rear for assistance.
5. Pull out the starting cord 6 at the starting handle slowly until the resistance is reached.
6. Pull quickly on the start cord and then release it slowly.
Do not pull out the starting cord completely and do not let the starting handle snap back
on the engine.
7. Pull the throttle slightly and the choke will automatically return to its original position.
8. The engine rotates at idle speed.
9. Before starting work, let the appliance warm up at idle for about 2-3 minutes and slowly start to
pull the throttle lever 3.
Starting with warm engine
1. Move ON / OFF switch 2 to position 1.
2. Leave the choke lever 4A on
3. Pull the starting cable on the starting handle until the engine starts.
Stop the engine
1. Release throttle 3.
2. Set the ON / OFF switch to position 0
