Original Bedienungsanleitung FUXTEC FX-PS152 / FX-PS162_de_en_fr_ita_rev06
47
with damaged or defective parts.
DO NOT use the device for any purpose other than trimming grass.
Never lift the nylon cutting head above knee height during operation.
Do not run the device on a slope if there is a chance of slipping or losing stability.
RELEASING THE NYLON THREAD
To release fresh thread, run the device at full throttle and tap the nylon cutting
head onto the lawn. The thread releases automatically. The blade in the
protective shield cuts off excess thread.
CAUTION: Remove grass deposits regularly to prevent overheating of the
drive axle. Grass deposits occur when fibers of the weed become entangled
around the shaft under the protective shield. This prevents the shaft from
cooling correctly. Remove grass deposits with a screwdriver or similar tool only when the
device is switched off.
When the device is appropriately equipped with a protective shield and nylon cutting head,
your device will trim unsightly weeds and large diameter tall grass in areas along fences,
walls, land, and around trees.
NOTE: Pay particular attention when trimming on brick or stone walls, etc., where rapid
weed wear will occur.
TRIM MORE ACCURATELY
Swing the trimmer's nylon cutting head horizontally
from side to side. Do not tilt the nylon cutting head
while working. For correct cutting height, trim in a
test area beforehand. Keep nylon cutting head at the
same level for even depth of cut.
TRIMMING AROUND TREES
Trim around logs with a slow approach; the thread should not collide with the log. Walk
around the tree from left to right—approach grass or weeds with the tip of the thread.
