Original Manual 5in1 Workbench FX-WB de_en_fr_ita_rev1
19
Workbench & Sawhorse mode
3. Firstly, set up the legs by following the same steps as detailed with scaffold mode
section.
4. Pull up the let switch on the side of each leg to release them, then pull the inner
legs out to the workbench height, 66cm or 80cm. There are 3 locking positions,
each for a height. The lowest one is for scaffold mode which is 52cm, the second
is 66cm and the highest is 80cm. Gently turn the workbench upright onto a stable,
level surface.
5. Please follow below steps to connect with a quick clamp.
1) Remove the small plastic part of your quick clamp(Fig 1);
2) Put the steel bar into our connector (Fig 2) and push the pin into the lock hole,
make sure they are connected firmly(Fig 3);
