803324
12
Zoom out
Zoom in
Vorherige Seite
1/23
Nächste Seite
11
Irregular Heartbeat Detector
This symbol - indicates that certain pulse irregularities were detected during the measurement.
In this case, the result may deviate from your normal basal blood pressure repeat the measurement.
Information for the physician on frequent appearance of the Irregular Heartbeat Symbol.
This instrument is an oscillometric blood pressure monitor device that also analyzes pulse frequency
during measurement. The instrument is clinically tested.
If pulse irregularities occur during measurement, the irregular heartbeat symbol is displayed after the
measurement. If the symbol appears more frequently (e.g. several times per week on measurements
performed daily) or if it suddenly appears more often than usual, we recommend the patient to seek
medical advice. The instrument does not replace a cardiac examination, but serves to detect pulse
irregularities at an early stage.
5.4 Error Indicates
The following symbol will appear on the display when measuring abnormal
SYMBOL
CAUSE
CORRECTION
No display appears Weak battery or improper
placement
Replace both batteries with new ones.
Check the battery installation for proper
placement of the battery polarities.
Er 1 Sensor abnormal
Check if the pump is working or not. If it is
working, then the problem is sensor
abnormal. Please send it to the local
distributor.
Er 2
Monitor could not detect pulse
wave or cannot calculate the
blood pressure data
Check if the air releasing is too slow or
not. If it is too slow, please check if there
is any dust in the tube plug of the cuff
and the cuff port in the device. If yes,
please clean and start the measurement
again. If no, please send the device back
to the local distributor.
Er 3
Measurement result is abnormal
(SYS35mmHg, DIA23mmHg)
Occasionally-measure for one more time
/ Always - send it to local distributor
Er 4
Too loose cuff or air leakage
(Cannot inflate to 30mmHg within
15s)
Tie the cuff correctly and make sure the
air plug is properly inserted in the unit
Er 5 The air tube is crimped
Correct it and make the measurement
again
Er 6 The sensor is sensing great
fluctuation in the pressure
Please keep quiet and don’t move
Er 7
The pressure that the sensor
sensing is over the limit
Please send back to the local distributor
Er 8
The demarcation is incorrect or
the device has not been
demarcated
Please send back to the local distributor
12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Fysic FB-160 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Fysic FB-160

Fysic FB-160 Bedienungsanleitung - Deutsch - 23 seiten

Fysic FB-160 Bedienungsanleitung - Holländisch - 23 seiten

Fysic FB-160 Bedienungsanleitung - Französisch - 23 seiten

Fysic FB-160 Bedienungsanleitung - Italienisch - 23 seiten

Fysic FB-160 Bedienungsanleitung - Spanisch - 22 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info