Bedienungsanleitung Fysic FPO 10 (Seite 1 von 2) (Englisch)

644210

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

FPO-10

Puls oximeter

Introduction:

The Fysic FPO-10 is a pulse Oximeter which

measures the percentage of the amount of oxy-

gen found in the blood.

Intended use:

The Fysic FPO-10 is a home device intended

for measuring the levels of oxygen in your blood

and your heart rate. The FPO-10 is NOT meant

for medical purposes or continuous treatment.

For questions in the medical eld, always consult

your doctor.

Measuring principle:

By shining an infra-red light through the skin, the

reected light will be compared with the emitted

light which will in turn analyze the color of the red

blood cells. This colour measured will reect the

amount of oxygen in the blood.

Do not use:

Do not use the FPO-10 with an irregular heart

beat (Atrial Fibrillation).

Installation:

The FPO-10 comes with two included batteries, a

wrist strap and a protective case.

Install batteries:

1. Slide the battery cover off of

the FPO-10

2. Insert the two supplied bat-

teries, be sure to take note

of the positive and negative

poles (+ and -)

3. Place the battery cover back onto the FPO-10

Fastening the wristband:

1. ush the thin cord through the hole on the FPO-

10 and then make a loop from the cord.

2. Put the thick part of the strap through the loop.

3. Pull the thick part of the cord all the way

through the loop tugging slightly to tighten it.

Use:

Preparations & tips:

• Make sure that you are familiar with the ope-

ration of the pulse Oximeter.

• Remove articial nails and/or nail polish.

• Avoid bright lights.

• Sit quietly before and during the taking of the

measurement.

Measurement:

1. Wash your hands before using.

2. Open the clip and place

your nger on the FPO-

10 with the nail facing

upwards, as shown on the adjacent picture;

use your middle nger preferably pushing it

gently towards the back of the Oximeter.

3. Turn on the FPO-10 by pressing the

on/off button.

4. If necessary, the reading direction of

the display can be changed by pres-

sing the on/off button repeatedly.

5. Do not move your nger during the

measurement.

6. Readings in the display:

- The “% SpO2” shows the percentage of

oxygen in the blood.

- The “bpmPR” gives the pulse rate of the

pulse per minute.

- The pulsating bar graph shows the

strength of the heartbeat.

- The heart rate can be seen at the bottom

of the display.

7. The FPO-10 will turn off 15 seconds after the

clip has been taken off the nger.

Setting an alarm:

You can set alarm tones to give alert signals when

the level of the oxygen in your blood, or the pulse

rate exceeds the adjustable upper or lower values.

1. Turn on the FPO-10 by quickly pressing the

on/off button.

2. Hold down the on/off button for more than one

second to open the settings menu.

3. Now release the on/off button. You will see

one of the following statements:

• The line with the star at the end is the active

line.

• Press quickly on the on/off button to move the

star to the next line.

• Press and hold the on/off button to change

the setting of the current line.

Settings

Sounds Setup

SPO2 Alm Hi * 100

SPO2 Alm Lo 94

PR Alm Hi 130

PR Alm Lo 50

+/- +

Exit

Settings

Alm Setup

Alm on

Beep * off

Restore Ok

Exit

on/off

button

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Fysic FPO 10 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Fysic FPO 10

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info