761916
23
Zoom out
Zoom in
Vorherige Seite
1/88
Nächste Seite
23
Installation en
Wall-mounting the appliance and
levelling it
1First remove the protective film from the back of the
appliance and, following installation, remove the
rest of the film.
2When mounting the appliance, ensure that it
engages properly with the mounting supports.
3If required, the appliance can be moved to the right
or to the left.
4Firmly tighten the screws for the mounting
supports. Hold the bracket firmly when doing so. ¨
5If no duct is to be fitted, screw in the two locking
screws without the bracket. ©
Connecting the pipes
If the extractor hood is to be operated in air extraction
mode, the pipes must be connected. If the extractor
hood is to be operated in air recirculation mode, the
activated charcoal filters provided must be fitted.
Note: If an aluminium pipe is being used, smooth the
connection area beforehand.
Exhaust air pipe, dia. 150 mm (recommended size)
Fit the exhaust air pipe directly to the air-pipe connector
and seal the joint.
Exhaust air pipe, dia. 120 mm
1Fit the reducing connector directly to the air-pipe
connector.
2
Attach the exhaust air pipe to the reducing connector.
3Use suitable means to seal both joints.
Attaching the flue duct
If the extractor hood is to be operated in exhaust-air
mode, a flue duct must be fitted.
The flue duct does not need to be fitted for air-
recirculation mode.
mWarning – Risk of injury!
From sharp edges during installation. Always wear
protective gloves while installing the appliance.
mWarning – Risk of electric shock!
Components inside the appliance may have sharp
edges. These may damage the connecting cable. Do not
kink or pinch the connecting cable during installation.
1Separate the flue duct sections by removing the
adhesive tape.
2Remove the pieces of protective film from both flue
duct sections.
3Push one flue duct section into the other.
Notes
To prevent scratches, lay paper over the edges
of the outer flue duct section to protect the
surface.
The slots of the inner flue duct section point
downwards.
4Place flue ducts sections on the appliance.
5Slide the inner flue duct section upwards, attach it
to the left and right sides of the retaining bracket,
and then slide it down to engage it. ¨
6Screw the flue duct section to the sides of the
retaining bracket using two screws. ©
7Clip the lower flue duct section in at the retaining
bracket. The connection cable must not be
damaged. ª
Note: If an air-recirculation optional accessory has been
fitted and the extractor hood is to be operated without a
flue duct, the cable must be wound onto the connector.
23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gaggenau AW250192 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Gaggenau AW250192

Gaggenau AW250192 Bedienungsanleitung - Deutsch, Holländisch, Französisch, Italienisch - 88 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info