Bedienungsanleitung Gaggenau BSP221 (Seite 27 von 40) (Englisch)

512145

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

en Cleaning and maintenance

6Place the descaling tablet in the compartment at

the back of the tank. Fill the tank with water up to

the "Max." mark (1.7 litres).

7Position the lid on the tank and click it into place.

8Slide the tank into the appliance.

9Close the appliance door. Press ™ to confirm. A

descaling time of 1 hour 50 minutes is displayed.

10 Press I to start. The descaling time will count down

on the display. The light in the cooking

compartment remains switched off.

Note: After approximately 1:30 hours, a message

appears in the display. Remove and drain the tank.

Clean the tank thoroughly. Fill the tank with fresh

water. Slide the tank into the appliance. Confirm by

pressing ™. Press I to start the rinsing process.

11 Once the descaling programme has ended, an

audible signal sounds. A message appears in the

display.

Wipe the cooking compartment dry with a soft cloth.

Cleaning the tank

Descaler residues are left in the tank after descaling.

You must therefore clean the tank once the descaling

program has ended.

1Remove the tank from the appliance and take off

the lid.

2Clean the tank and lid in the dishwasher.

Removing the wire racks

The wire racks can be removed for cleaning.

Removing the wire racks

1Place a dishcloth in the cooking compartment to

protect the enamel from scratches.

2Lift the wire racks slightly at the front (Fig. A) and

pull them out sideways towards the front (Fig. B).

You can clean the wire racks in the dishwasher.

Refitting the wire racks

1Attach the wire racks the right way round – with the

end stop at the back.

2Slide the back of wire racks onto the bolts, then

reattach them at the front.

O

0D[

/



Trouble shooting en

Trouble shooting

Trouble shooti ng

Malfunctions often have simple explanations. Please

read the following notes before calling the after-sales

service.

mWarning – Risk of electric shock!

Incorrect repairs are dangerous. Repairs may only be

carried out and damaged power cables replaced by one

of our trained after-sales technicians. If the appliance is

defective, unplug the appliance from the mains or switch

off the circuit breaker in the fuse box. Contact the after-

sales service.

mWarning – Risk of injury!

The light emitted by LED lights is very dazzling, and can

damage the eyes (risk group 1). Do not look directly into

the switched on LED lights for longer than 100seconds.

LED lights

Defective LED lights must only be replaced by the

manufacturer, their customer service department or a

licensed technician (electrician).

Disruption Possible cause Solution

Appliance not working, no display Plug not inserted Connect the appliance to the electricity

mains

Power failure Check whether other kitchen appliances

are working

Fuse defective Check in the fuse box whether the fuse

for the appliance is in working order

Operating error Switch off the fuse for the appliance in

the fuse box and switch it on again after

about 60seconds

The appliance does not work, the dis-

play shows "Device locked. Descaling

required."

Build-up of limescale in the appliance Start the descaling programme

~ "Descaling programme"

on page 25

Despite descaling, "Please descale"

appears on the display

Build-up of limescale in the appliance,

wrong descaler used

Use the specified descaling tablets,

start the descaling programme

~ "Descaling programme"

on page 25

Appliance cannot be started Appliance door is not quite closed Close appliance door

The appliance does not work, the dis-

play shows "E182"

No water available in the appliance Take out the water tank and verify that

the suction pipe in the tank is straight,

not kinked. Please contact the after-

sales service if the error message per-

sists.

The appliance is not working and the

display does not respond. 0 appears

on the display

Childproof lock activated Deactivating the childproof lock

~ "Childproof lock" on page 18

Appliance switches off on its own Safety shut-off: the appliance has not

been operated for longer than 12hours

Confirm the message with ™, switch off

the appliance and set it again.

Appliance does not heat up, ° appears

in the display

Appliance is in demo mode Deactivate the demo mode in the basic

settings

The appliance cannot be started, the

display shows an error message

The water tank is empty Fill the water tank

Powerful steam outlet at the top of the

door

The operating mode has been changed This is normal

A lot of steam escapes at the side of the

door

Door seal soiled or loose Clean the door seal and insert it in the

groove

A whistling noise occurs during heating Noises may occur during steam genera-

tion

This is normal

There is a "pop" noise during cooking Cold/warm effect with frozen food,

caused by the steam

This is normal

Steaming is not possible Build-up of limescale in the appliance.

Appliance must be descaled to avoid

damage to the appliance

Starting the descaling

program~ "Descaling programme"

on page 25

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gaggenau BSP221 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Gaggenau BSP221

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info