27
Electrical connection
Connect the appliance to an alternating current
only, ranging from 220 V to 240 V and 50 Hz or
60 Hz via a correctly installed socket with
protective earth conductor. See rating plate for
required fusing 9J.
The socket must be near the appliance and freely
accessible following installation.
The connection may be modified by technicians
only.
A power cord extension may be purchased from
customer service only.
Use only a residual current operated circuit-
breaker which features the symbol ‚. Only this
extension guarantees compliance with the
currently valid regulations.
The appliance features a water damage protection
system. Please note the system will not function
unless the power supply is connected.
Removing the appliance
Also observe the sequence of worksteps here.
1 Disconnect the appliance from the power supply.
2 Turn off the water supply.
3 Disconnect the waste water and fresh water
connections.
4 Loosen the fastening screws under the worktop.
5 If fitted, remove the base panel.
6 Pull out the appliance, carefully pulling the hose
behind.
Transportation
Empty the dishwasher and secure loose parts.
Drain the appliance according to the following
steps:
1 Turn on the tap.
2 Open the door.
3 Switch on ON/OFF switch (. The displays of
the last selected programme light up.
4 Select programme with the highest temperature.
The expected programme duration is indicated on
the numerical display 8.
5 Press START button )".
6 Close the door.
Programme sequence starts.
7 Open door after approx. 4 minutes.
8 Press START button )" until ‹:‹‚ is indicated
on the digital display.
9 Close the door.
10 Open door after approx. 1 minute.
The numerical display indicates ‹:‹‹.
11 Switch the appliance off ( and turn the tap off.
Transport appliance upright only.
(This prevents residual water from running into the
machine control and damaging the programme
sequence.)
Protection against frost
If the appliance is in a room where there is a risk of
frost (e.g. holiday home), empty the appliance
completely (see Transportation).
Turn off the tap, disconnect supply hose and
drain water.
