17
Switching off automatically after
the end of the programme
To save energy, the dishwasher is switched off
1 minute after the programme ends (factory setting).
Automatic disconnection can be adjusted from ˜:‹‹
to ˜:‹ƒ.
1 Open the door.
2 Switch on ON/OFF switch (.
3 Hold down programme button # and press
START button )" until •:‹... is indicated on the
digital display.
4 Release both buttons.
The LED for button # flashes and the digital
display 8 displays the factory setting •:‹….
5 Press programme button # until the factory set
value ˜:‹‚ is indicated on the digital
display 8.
To change the setting:
1 Press programme button 3.
Each time the button is pressed, the set value
increases by one level; when the value of ˜:‹ƒ
has been reached, the display jumps back
to ˜:‹‹ (off).
2 Press START button )".
The set value is saved.
3 Close the door.
Switching off the appliance
Short time after the end of the programme:
1 Open the door.
2 Switch off ON/OFF switch (.
3 Turn off the tap (not applicable if Aqua-Stop
fitted).
4 Remove the utensils when they have cooled down.
ã=Warning
At the end of the programme please open the door
fully and not partially when emptying the dishwasher.
Any escaping water vapour could damage sensitive
worktops.
Interrupting the programme
1 Open the door.
2 Switch off ON/OFF switch (.
The LEDs go out. The programme is saved.
If the door was opened on an appliance which has
a warm water connection or is heated, first leave
the door ajar for several minutes and then close.
Otherwise, expansion (pressure) may cause the
appliance door to spring open or water to run out
of the appliance.
3 To continue the programme, switch on the ON/
OFF switch ( again.
4 Close the door.
Terminating the programme (Reset)
1 Open the door.
2 Press START button )" for approx. 3 sec.
The numerical display 8 indicates ‹:‹‚.
3 Close the door.
The programme sequence lasts approx. 1 min. On
the digital display 8 is indicated ‹:‹‹.
4 Open the door.
5 Switch off ON/OFF switch (.
6 Close the door.
Changing the programme
When the START button )" has been pressed, the
programme cannot be changed.
The only way a programme can be changed is by
Cancel programme (Reset).
˜:‹‹ Appliance does not switch off automatically
˜:‹‚ Off after 1 min
˜:‹ƒ Off after 120 min
