25
Warm water connection
The dishwasher can be connected to cold or hot water
up to max. 60 °C.
Connection to hot water is recommended if the hot
water can be supplied by energetically favourable
means and from a suitable installation, e.g. solar
heating system with circulation line.
This will save energy and time.
The hot water setting ‘:‹‚ allows you to adjust your
appliance optimally to operation with hot water.
It is recommended to have a water temperature
(temperature of the incoming water) of at least 40 °C
and no more than 60 °C.
It is not recommended to connect the appliance to hot
water if the water is supplied from an electric boiler.
Setting hot water:
1 Open the door.
2 Switch on ON/OFF switch (.
3 Hold down programme button # and press
START button )" until •:‹... is indicated on the
digital display.
4 Release both buttons.
The LED for button # flashes and the digital
display 8 displays the factory setting •:‹….
5 Press programme button # until the factory set
value ‘:‹‹ is indicated on the digital
display 8.
To change the setting:
1 By pressing the 3 button, you can switch the
hot water setting off ‘:‹‹ or on ‘:‹‚.
2 Press START button )".
The set value is saved.
3 Close the door.
Electrical connection
Connect the appliance to an alternating current
only, ranging from 220 V to 240 V and 50 Hz via
a correctly installed socket with protective earth
conductor. See rating plate for required fusing
9J.
The socket must be near the appliance and freely
accessible following installation.
The connection may be modified by technicians
only.
A power cord extension may be purchased from
customer service only.
Use only a residual-current-operated circuit-
breaker which features the ‚ symbol. Only this
extension guarantees compliance with the
currently valid regulations.
The appliance features a water damage protection
system. Please note the system will not function
unless the power supply is connected.
Removing the appliance
Also observe the sequence of worksteps here.
1 Disconnect the appliance from the power supply.
2 Turn off the water supply.
3 Disconnect the waste water and fresh water
connections.
4 Loosen the fastening screws under the worktop.
5 If fitted, remove the base panel.
6 Pull out the appliance, carefully pulling the hose
behind.
