7.4 Installing the appliance
– Produce the recess for one or several Vario
appliance(s) in your worktop. Proceed as
indicated on the installation sketch and the
dimension table. The dimension table contains
details of the space requirement for the trim
between the appliances.
Important: the angle between the cut surface
and the worktop must amount to 90° (Fig. 10).
– Mark the centre of the recess exactly.
Secure the longer securing rail on the rear edge
and the shorter securing rail on the front edge of
the recess. Make sure that the lugs of the
securing rail lie on the worktop and that the
centre marking of the securing rail is precisely
flush with the centre marking on the worktop
(Fig. 11).
– Lower the appliance into the worktop. Make
sure that the engaging lugs on the appliance
lie exactly on the clamping springs. Press the
appliance firmly into the worktop. The engaging
lugs on the appliance “snap" into the clamping
springs (Fig. 12).
Note: When installing the appliance in granite
or marble worktops, have the holes produced by
a specialist or stick on the securing rails with a
temperature-resistant 2-component adhesive (metal
on stone).
16 5080006243ind01 en 03.04 SK
Fig. 10
Fig. 11
Fig. 12
Secure the appliance cover on the appliance
before installation (see VD 201-010 assembly
instructions).
Note:
Several appliances can also be installed in indi-
vidual recesses, as long as a minimum clearance
of 40 mm is kept to between the appliances.
