Removing odors from
refrigerator
➢ Remove all food.
➢ Disconnect refrigerator.
➢ Clean the following items using the
appropriate instructions in the Care
and Cleaning table.
–Walls, floor and ceiling of cabinet
interior
–Drawers, shelves and gaskets
according to the instructions in this
section.
➢ Pay special attention to clean all
crevices by completing the following
steps.
– Dilute mild detergent and brush
solution into crevices using a
plastic bristle brush.
– Let stand for 5 minutes.
– Rinse surfaces with warm water.
Dry surfaces with a soft, clean
cloth.
➢ Wash and dry all bottles, containers
and jars. Discard spoiled or expired
items.
➢ Wrap or store odor-causing foods in
tightly sealed containers to prevent
reoccurring odors.
➢ Connect power to refrigerator and
return food to refrigerator.
➢ After 24 hours, check if odor has been
eliminated.
If odor is still present:
➢ Remove drawers and place on top
shelf of refrigerator.
➢ Pack refrigerator and freezer sections
– including doors – with crumpled
sheets of black and white newspaper.
➢ Place charcoal briquettes randomly on
crumpled newspaper in both freezer
and refrigerator compartments.
➢ Close doors and let stand 24-48
hours.
To avoid personal injury or property
damage, observe the following:
➢ Allow light bulb to cool.
➢ Wear gloves when replacing light
bulb.
CAUTION
To avoid electrical shock which can
cause severe personal injury or death,
disconnect power to refrigerator
before replacing light bulb. After
replacing light bulb, connect power.
WARNING
Energy saving ideas
This refrigerator is designed to be one of
the most energy efficient refrigerators
available. Reduce energy use by
observing the following:
➢ Operate in normal household
temperatures of 16° to 43° C away
from heat sources and direct sunlight.
➢ Set refrigerator, freezer and Chiller
Fresh™ system controls no colder
than necessary.
➢ Keep freezer section full.
➢ Keep door gaskets clean and pliable.
Replace gaskets if worn.
➢ Keep condenser coils clean.
Remove and replace
light bulbs
Fresh food section
➢ Remove screw from light shield.
Retain for replacement.
➢ Slide shield toward back of
compartment to release from light
assembly.
➢ Remove light bulbs.
➢ Replace with appliance bulbs no
greater than 40 watts.
➢ Replace light bulb cover by inserting
tabs on light shield into liner holes on
each side of light assembly. Slide
shield toward front of refrigerator until
it locks into place. DO NOT force
shield beyond locking point. Doing so
may damage light shield.
➢ Replace light shield screw.
Freezer
➢ Pinch rear tabs on light cover and pull
straight down.
➢ Remove light bulb.
➢ Replace bulb with appliance bulb no
greater than 40 watts.
➢ Insert front tabs of light cover into
freezer liner and snap rear portion
over light assembly until rear tabs
engage.
