22
GB
Charging the Accu when not
in the mower:
1. Open both catches
7
on the Accu cover
8
and open up the Accu cover
8
.
2. Release retaining strap
0
and take
Accu-Pack
9
out of the mower.
3. Insert charging plug
N
of the charger
in the charging socket
C
.
4. Insert the mains plug of the charger
O
in a mains power socket.
5. The Accu is being charged whilst
the red charging LED
P
of the
charger is illuminated (this can take
up to 24 hours if the Accu is flat).
The charger can remain plugged in
to maintain the charge.
8. Troubleshooting
DANGER! Cutting tool can cause injuries!
V Before rectifying faults, wait for the cutting tool to
stop, wear suitable work gloves and pull out the
safety key.
Fault Possible cause Remedy
Motor will not start Safety key not inserted. v Insert the safety key into the
socket.
Charging plug of charger is v Unplug charging plug from
plugged into the charging socket. charging socket and insert
safety key.
Tab on Accu loose. v Open the cover and push
the tab receptacle onto the
tab.
Motor jamming and Blocked by foreign body. 1. Switch off mower.
making a noise Blocking protection activated. 2. Remove key.
(Red Error-LED flashes). 3. Remove foreign body.
Accu charge too low for high v Reduce load or charge
cutting load. Accu.
Loud noises, mower Screws on motor, its fixing or on v Check mower for loose
rattling the mower casing loose. components and tighten
these if necessary.
Runs unevenly, mower Blade damaged or blade v Have blade tightened or
vibrates strongly mounting released from motor replaced by an authorised
shaft. specialist dealer or
GARDENA-Service.
Out of balance because of v Clean mower (see
very dirty blade. 7. Maintenance). If this
does not rectify the fault,
contact GARDENA Service.
7
0
9
8
C
O
P
N
