687480
5
Zoom out
Zoom in
Vorherige Seite
1/9
Nächste Seite
EN
9
2. ASSEMBLY
DANGER! Risk of injury!
Cut injury when the blade turns or the product starts
accidentally.
v Wait for the blade to stop, disconnect the product from the
mains and use gloves before you do assembly.
To connect the lower handle [ Fig. A1 ]:
1. Put both lower handles
1
in the product.
Make sure that the handles are fully in place and the handle hole
is inline with the threaded hole.
2. Put both washers
2
on the wing screws
3
.
3. Put both wing screws
3
in the threaded holes in the product.
4. Tighten the wing screws
3
.
5. Always allow the machine to cool down before storing.
6. When servicing the blades be aware that, even though the power source is
switched off, the blades can still be moved.
7. Replace worn or damaged parts for safety. Use only genuine replacement
parts and accessories.
Additional safety warnings
Electrical safety
DANGER! Cardiac arrest!
This product makes an electromagnetic field while it operates. This field may
under some conditions interfere with active or passive medical implants. To
decrease the risk of conditions that can possibly injure or kill, we recommend
persons with medical implants to speak with their physician and the medical
implant manufacturer before you operate the product.
Before use, examine the cable for signs of damage or ageing. If the cable is
found to be defective, take the product to an Authorised Service Centre and have
the cable replaced.
Do not use the product if the electric cables are damaged or worn.
Immediately disconnect from the mains if the cable is cut, or the insulation is
damaged. Do not touch the electric cable until the cable has been disconnected.
Do not repair a cut or damaged cable. Replace it with a new one.
The extension cable must be uncoiled. Coiled cables can overheat and reduce
the efficiency of your mower.
Keep the extension cable away from product, always work away from the power
point mowing up and down, never in circles.
Do not pull cable around sharp objects.
Always switch off at the mains before disconnecting any plug, cable connector or
extension cable.
Stop the engine, disconnect the mains and examine the cable for damage or
ageing before you wind the cable for storage. Do not repair a damaged cable,
replace it with a new one. Use only genuine replacement cable.
Always wind the cable carefully, avoid kinking.
Do not carry the product by the cable.
Do not pull on the cable to disconnect any of the plugs.
Use only on AC mains supply voltage shown on the product rating label.
Our products are double insulated to EN60335. Do not connect an earth to any
part of the product.
Check the working area for hidden cables.
Do not use for pond care or close to water.
Personal safety
DANGER! Risk of suffocation!
Small parts can be easily swallowed. There is also a risk that the polybag can suf-
focate toddlers. Keep toddlers away when you assemble the product.
Do not use in explosive atmosphere.
Never operate the product when you are tired, ill or under the influence of alcohol,
drugs or medicine.
Do not overload the mower.
Use gloves, wear slip resistant shoes and wear eye protection.
Do not use under wet conditions.
Do not disassemble the product further than the delivery status.
Only start the mower with an upright standed handle.
Do not use the start levers alternately.
Use the handles carefully.
Safety Cut-Out
The engine is protected by a Safety Cut-Out which is activated when the blade
becomes jammed or if the engine is overloaded. When this occurs, stop and dis-
connect the product from the mains. The Safety Cut-Out will only reset when
you release the start / stop lever. Clear any obstruction and wait for a few minutes
for the Safety Cut-Out to reset before you continue to use the product.
To connect the upper handle [ Fig. A2 ]:
1. Put the upper handle
4
on the lower handle
1
.
Make sure that the handles are fully in place and the handle holes are
inline.
2. Push the screws
5
through the holes.
3. Put the washers
2
and the wing nuts
6
on the screws
5
.
4. Tighten the wing nuts
6
.
To fix the cable to the handle [ Fig. A3 ]:
1. Fix the cable
7
to the handle with the clip
8
.
2. Check that the cable
7
is not trapped between the lower and the
upper handle.
To assemble the grass box [ Fig. A4 / A5 ]:
1. Only for PowerMax 1400/34: Connect both parts
ß
G1
/
ß
G2
of the grass
box until the connections click.
Make sure that all connections are connected.
2. Turn the cover
0
on the grass box.
Make sure that the cover
0
aligns to the grass box.
3. Push the cover
0
on the grass box until the connections click.
Make sure that all connections are connected.
4. Push the handle
q
into the cover
0
until it clicks.
5. Push the chute
9
into the grass box and pull the chute
9
forward until
it audibly engages.
3. OPERATION
DANGER! Risk of injury!
Cut injury when the blade turns or the product starts
accidentally.
v Wait for the blade to stop, disconnect the product from the
mains and use gloves before you connect or transport the
product.
To connect the mower [ Fig. O1 ]:
DANGER! Electric shock!
To avoid damage to the plug
r
the extension cable
e
must be inserted into the cable lock
t
.
v Before you operate insert the extension cable
e
into the cable
lock
t
.
1. Connect the socket
w
of the extension cable
e
to the plug
r
.
2. Loop the extension cable
e
, insert the loop into the cable lock
t
and
pull tight.
3. Connect the extension cable
e
into a 230 V mains socket.
To start the mower [ Fig. O2 ]:
DANGER! Risk of injury!
Risk of injury if the product does not stop when you
release the start lever.
v Do not bypass the safety devices or switches. For example do
not attach the start lever
u
to the handle.
To start:
The product is fitted with a two-handed safety device (start lever
u
with safety interlock
z
) to prevent the product from being turned
on by accident. Contact the GARDENA service if this is not garan-
teed.
There are two start levers
u
fitted. Either one have to be used to start.
1. Push the safety interlock
z
with one hand and pull the start lever
u
with the other hand.
2. Release the safety interlock
z
.
The product will start.
To stop:
1. Release the start lever
u
.
To adjust the cutting height [ Fig. O3 ]:
The cutting height can be adjusted from 2 to 6 cm in 12 positions.
1. Push and turn the adjust wheel
o
clockwise to lower the cutting
height.
2. Push and turn the adjust wheel
o
counterclockwise to increase the
cutting height.
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gardena 5032 PowerMax 1200-32 - 2018 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Gardena 5032 PowerMax 1200-32 - 2018

Gardena 5032 PowerMax 1200-32 - 2018 Bedienungsanleitung - Deutsch - 9 seiten

Gardena 5032 PowerMax 1200-32 - 2018 Bedienungsanleitung - Holländisch - 9 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info