How to Mow
Your product can be used to cut grass using the
following methods:-
1. Grassbox Fitted:- grass is collected effectively
and compacted into the grassbox. (P1)
2. Mulch Plug Fitted - Powermax 37E/42E only:- only
grass cuttings are finely chopped to return
nutrients to your lawn (V3).
3. Rear Discharge:- Effectively cuts long grass with no
need to empty the grassbox (P2)
How to Mow
1. Start mowing the edge of the lawn nearest to the
power point so the cable is laid out on the lawn
you have already cut.
2. Mow twice a week during the growing season,
your lawn will suffer if more than a third of its
length is cut at one time.
Do Not Overload Your Mower
Mowing long thick grass may cause the motor speed
to drop, you will hear a change in the motor sound. If
the motor speed drops you may overload your
lawnmower which may cause damage. When
mowing in long thick grass a first cut with the cutting
height set higher will help reduce the load. See
Cutting Height Adjustment.
Edging Comb (W1)
Enables cutting up close to walls and fences
Caring for your Lawnmower
Cleaning
• USE GLOVES
• IMPORTANT:- It is very important that you keep
your lawnmower clean. Grass clippings left in any
of the air intakes or under the deck could become
a potential fire hazard.
1. Remove grass from under the deck with brush.
(X1)
2. Using a soft brush - remove grass clippings from
all air intakes (X2), the discharge chute (X3) and
the grass box (X4).
3. Using a soft brush, remove grass clippings from
the vision window (X5).
4. Wipe over the surface of your lawnmower with a
dry cloth (X6).
• IMPORTANT:- Never use water for cleaning your
lawnmower. Do not clean with chemicals,
including petrol, or solvents - some can destroy
critical plastic parts.
Storing your Lawnmower:
• Store in a dry place where your lawnmower is
protected from damage
Powermax 34E
• Loosen the wing knobs to enable the handles to
be folded over the product (Z1) ensuring that the
upper handle is supported.
Powermax 37E/42E
• Loosen the tilt adjusters to enable the handles to
be folded over the product (Z2) ensuring that the
upper handle is supported. Ensure that the
locking discs are fully unscrewed (Y1) before
folding.
• The product can be stored upright on its back
wheels as illustrated in Fig Z3.
At the End of the Mowing Season
1. Replace bolts, nuts or screws, if necessary.
2. Clean your lawnmower thoroughly.
3. Make sure that the electric cable is stored
correctly to prevent damage.
Fault Finding Hints
Fails to Operate
1. Is the correct Starting procedure being followed?
See ‘To Start your Lawnmower’
2. Is the Power Turned On?
3. Check the fuse in the plug, if blown replace.
4. Fuse continues to blow?
Immediately disconnect from the mains electricity
supply and consult your GARDENA Service
Centre.
Poor Grass Collection
1. Disconnect from the mains electricity supply.
2. Clean the outside of the air intakes, the discharge
chute and the underside of the deck.
3. Raise to a higher height of cut. See Cutting
Height Adjustment.
4. If poor collection persists.
Immediately disconnect from the mains electricity
supply and consult your GARDENA Service
Centre.
Excessive Vibration
1. Disconnect from the mains electricity supply.
2. Check that the blade is fitted correctly?
3. If the blade is damaged or worn, replace it with a
new one.
4. If vibration persists?
Immediately disconnect from the mains electricity
supply and consult your GARDENA Service
Centre.
Lawnmower becomes heavy to push
1. Disconnect from the mains electricity supply.
2. In long grass or uneven ground, the height of cut
should be raised to a higher position. See Cutting
Height Adjustment.
3. Check that the wheels can rotate freely.
4. If problem persists?
Immediately disconnect from the mains electricity
supply and consult your GARDENA Service
Centre.
ENGLISH - 4
Replacement Parts
Blade
GARDENA 34E Article no.: 4015-20
GARDENA 37E Article no.: 4016-20
GARDENA 42E Article no.: 4017-20
Part no.: 585207101
Part no.: 585207001
Part no.: 585206901
