Bedienungsanleitung Gardena SILENO plus R160 Li-LiC (Seite 44 von 56) (Englisch)

687465

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Message Cause Action

Outside working area

The boundary wire connections to the charg-

ing station are crossed.

Check that the boundary wire is connected

correctly.

The boundary wire is too close to the edge of

the working area.

Check that the boundary wire has been laid

according to the instructions. See

Installation

on page 26

The working area slopes too much by the

boundary loop.

The boundary wire is laid in the wrong direc-

tion around an island.

Disturbances from metal objects (fences, re-

inforcement steel) or buried cables close by.

Try moving the boundary wire.

The robotic lawnmower finds it hard to distin-

guish the signal from another robotic lawn-

mower installation close by.

Place the robotic lawnmower in the charging

station and generate a new loop signal, see

New loop signal on page 26

Empty battery

The robotic lawnmower cannot find the charg-

ing station.

Check that the charging station and the guide

wire are installed in accordance with the in-

structions. See

Installation of the guide wire

on page 18

The guide wire is broken or not connected. Find out where the break is and rectify it.

The battery is spent. Replace the battery. See

Battery on page 41

The charging station’s antenna is defective. Check if the indicator lamp in the charging

station flashes red. See

Indicator lamp in the

charging station on page 47

Wrong PIN code

Wrong PIN code has been entered. Five at-

tempts are permitted, and the keypad is then

blocked for five minutes.

Enter the correct PIN code. Contact your lo-

cal GARDENA representative if you forget the

PIN code.

No drive

The robotic lawnmower has got caught in

something.

Free the robotic lawnmower and rectify the

reason for the lack of drive. If it is due to wet

grass, wait until the lawn has dried before us-

ing the robotic lawnmower.

The working area includes a steep slope. Maximum guaranteed slope is 40%. Steeper

slopes should be isolated. See

Slopes on

page 16

The guide wire is not laid at an angle on a

slope.

If the guide wire is laid on a slope, it must be

laid at an angle across the slope. See

Instal-

lation of the guide wire on page 18

Wheel motor overloa-

ded, right

The robotic lawnmower has got caught in

something.

Free the robotic lawnmower and rectify the

reason for the lack of drive. If it is due to wet

grass, wait until the lawn has dried before us-

ing the robotic lawnmower.

Wheel motor overloa-

ded, left

Charging station

blocked

The contact between the charging strips and

contact strips may be poor and the robotic

lawnmower has made a number of attempts

to charge.

Put the robotic lawnmower in the charging

station and check that the charging strips and

contact strips make good contact.

An object is obstructing the robotic lawnmow-

er.

Remove the object.

The charging station is tilted or bent. Confirm that the charging station is placed on

a fully flat and horizontal ground. The charg-

ing station must not be tilted or bent.

44 - Troubleshooting 307 - 002 - 11.10.2017

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gardena SILENO plus R160 Li-LiC Seite 44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Gardena SILENO plus R160 Li-LiC

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info