Bedienungsanleitung Gardenline DM46P-DO160 (Seite 15 von 20) (Englisch)

724642

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

4 Stroke Petrol Lawn Mower

AFTER SALES SUPPORT

e-mail: help@powertoolsupport.com

1800 909 909

MODEL: №. DM46P-DO160 • 09/2018 • 60751

(toll free)

AFTER SALES SUPPORT

(toll free)

4 Stroke Petrol Lawn Mower

e-mail: help@powertoolsupport.com1800 909 909

MODEL: №. DM46P-DO160 • 09/2018 • 60751

26 27

Maintenance

Replacing the Blades

Note. Before making any adjustment or maintenance procedures to the

mower ensure it is turned o and the spark plug lead is removed.

Note. Wear heavy gloves to protect your hands.

1. Tilt the mower back (Fig U) so the spark plug (24) is facing up, and

disconnect the spark, by pulling spark plug cover (24) o.

2. Whilst securely holding the bar blade (26) with gloves on, use a 17mm

spanner (not supplied) to undo the blade bolt (27). (Fig V)

3. Remove the bar blade (26), and be careful not to slide the blade adaptor

o and dislodge the key on the shaft. (Fig W)

4. Clean dirt and grass from around the blade mounting area.

5. Replace the bar blade (26), ensuring you hold onto the adaptor whilst

tightening the blade bolt.

IMPORTANT: Ensure the two drive lugs on the adaptor are engaged in the

two holes in the blade. (Fig X)

6. Tighten the blade bolt tightly (40-50Nm). (Fig V)

Check lawn mower blades regularly. Look for damage, bends and dullness.

Blades should be replaced every year or two depending on usage, or when

they become worn and no longer cut the grass cleanly.

The performance of grass catching can also reduce if the blade become

worn. Replacement blades are available for purchase from

https://help.tools/ or by calling 1800 909 909.

X.W.V.

TIGHTEN

LOOSEN

Maintenance Maintenance

Air Filter Maintenance

WARNING: Ensure the motor is switched o

before undertaking this task.

IMPORTANT: A dirty air lter (20) will restrict air ow to the carburettor.

To prevent carburettor malfunction, service the air lter (20) regularly.

Check that the air lter (20) is clean and dry of dirt.

Filters thick with debris will not allow the engine to breathe and result in

dicult starting and poor engine performance.

The air lter (20) should be checked after approximately 25-50 hours of use,

or annually.

1. Open the air lter cover (21) by pushing in the rear

tab to release the clip, and then pushing the cover

back and away to release the 2 front clips and the

full air lter cover (Fig Y).

2. Remove the foam element (Fig Z).

3. If the air lter (20) is excessively dirty, replace with

a new lter.

4. Wash the air lter (20) in liquid detergent and

water. Then allow it to thoroughly air dry.

5. Re-install the air lter (20) and put the air lter

cover (21) back on ensuring the clips are securely

in place.

CAUTION: Never use fuel or low burning paint

solvents to clean the air lter (20). A re or explosion

could result.

CAUTION: Ensure the air lter (20) is dry before

re-tting.

Replacement air lters are available from https://help.tools/

or by calling Customer Service on 1800 909 909.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gardenline DM46P-DO160 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info