Bedienungsanleitung Gardenline YR-HT250 (Seite 10 von 19) (Englisch)

724657

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

25cc 4 Stroke Petrol Hedge Trimmer

AFTER SALES SUPPORT

e-mail: help@powertoolsupport.com

1800 909 909

MODEL: №. YR-HT250 • 10/2017 • 52742

(toll free)

AFTER SALES SUPPORT

(toll free)

e-mail: help@powertoolsupport.com1800 909 909

MODEL: №. YR-HT250 • 10/2017 • 52742

25cc 4 Stroke Petrol Hedge Trimmer

16 17

7. Pull the recoil starter (9) lightly until you feel

resistance then pull quickly until the engine

starts (Fig M) (Under full choke it may only

run for 1 or 2 seconds). A smooth rapid pull is

required for a strong spark. Do not pull the cord

with a jerk or release it until fully rewound.

8. Once the engine starts allow to run for 10

seconds.

NOTE: If the engine starts and then stops, even

for 1 sec, move the choke lever (red) (20) to the

mid way position between the full choke and no

choke position and pull the recoil starter (9) to

restart.

WARNING: On start up the oscillating blades

may be operational due to the setting of the

starting throttle. Be well aware of this condition

9. Once the engine is fully warm ensure the choke

lever (red) (20) is down fully to the run position.

(warm start) (Fig N).

10. If the engine fails to start, repeat steps 1

through 9.

NOTE: If the engine fails to start after repeated

attempts, refer to Troubleshooting section.

NOTE: Always pull the recoil starter (9) straight

out. Pulling the recoil starter (9) at an angle will

cause it to rub against the eyelet. This friction

will cause the cord to fray and wear more

quickly. Do not pull the end of the cord, this can

damage the recoil starter (9). Always hold the

recoil starter (9) handle when the cord retracts.

Never allow the cord to snap back from the

extended position. This could cause the cord to

snag or fray and also damage the recoil starter

(9) assembly.

1. Place the hedge trimmer upright on a rm at surface

2. Move the on/o switch (10) to the ON position by pressing the section

of the switch marked with an “I” (Fig H).

3. This hedge trimmer has a 2 position choke: Full Choke and No Choke.

Start position (choke closed / full choke)

Run position (choke open / no choke)

4. Move the choke lever (red) (20) towards the front of the hedge trimmer

(towards the blades) to the full choke or cold start position (Fig I). This

direction also indicated on the housing (Fig J).

NOTE. This is not required if the engine is already warm.

5. Push the primer bulb (19) 6-10 times, until the primer bulb is rm to

press, or until there are no air bubbles visible in the fuel discharge line

(Fig K/L).

NOTE: When the carburettor has sucient fuel for starting, the excess

fuel as you pump the primer bulb (19) is bypassed back into the fuel

tank (15) through the clear fuel line.

NOTE: The primer bulb (19) is located behind the left hand side of the

air lter cover (when viewing from the rear handle end of the unit) and

is located above where the clear and black fuel lines can be seen.

NOTE. For cold starting this is an important step.

6. Check the ignition on/o switch (10) is in the downward ON position as

indicated with an “I” (Fig H).

J.I.H.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gardenline YR-HT250 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info