Bedienungsanleitung Gardenline YR-HT250 (Seite 14 von 19) (Englisch)

724657

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

25cc 4 Stroke Petrol Hedge Trimmer

AFTER SALES SUPPORT

e-mail: help@powertoolsupport.com

1800 909 909

MODEL: №. YR-HT250 • 10/2017 • 52742

(toll free)

AFTER SALES SUPPORT

(toll free)

e-mail: help@powertoolsupport.com1800 909 909

MODEL: №. YR-HT250 • 10/2017 • 52742

25cc 4 Stroke Petrol Hedge Trimmer

24 25

2. TRIMMING NEW GROWTH

A wide, sweeping motion, feeding the blade teeth

through the twigs is most eective.

A slight downward tilt of the blades (1), in the

direction of motion gives the best cutting (Fig V).

3. LEVEL HEDGES

To obtain level hedges, a piece of string can be

stretched along the length of the hedge as a

guide.

CAUTION: Do not use the hedge trimmer for

cutting stems greater than 24mm. Use the hedge

trimmer only for cutting normal shrubbery found

around houses and buildings.

4. SIDE-TRIMMING HEDGES

Hold the trimmer as shown and begin at the

bottom and sweep up (Fig U).

Blade Maintenance

WARNING: Ensure the engine is switched o before undertaking all

maintenance work / tasks.

Your hedge trimmer should be stopped and oiled occasionally during use.

1. The cutting blades (1) are made from high quality, hardened steel and

with normal usage, they will not require resharpening. However, if you

accidentally hit a wire fence, stones, glass or other hard objects, you may put

a nick in the blades (1).

There is no need to remove this nick as long as it does not interfere with

the movement of the blade. If it does interfere, stop the engine and use a

sharpening stone to remove the nick.

2. If you drop the hedge trimmer, carefully inspect it for damage. If the

blades/s (1) is bent, the housing cracked, or handles broken or if you see any

other condition that may aect the hedge trimmer’s operation contact an

authorised service centre for repairs before using again.

3. Fertilisers and other garden chemicals contain agents greatly accelerate

the corrosion of metals. Do not store the hedge trimmer on or adjacent to

fertilisers or chemicals.

4. With the unit stopped, use only mild soap and a damp cloth to clean the

outside of the hedge trimmer. Never let any liquid get inside the tool; never

immerse any part of the hedge trimmer into a liquid.

Blade Lubrication

WARNING: Before lubricating, be sure your hedge

trimmer is switched o and blades (1) have come

to a complete stop.

For easier operation and longer blade life,

lubricate the blade before and after each use.

Apply light machine oil along the edge of the

blade/s (1) bar (Fig W).

Greasing

The engine requires re-greasing after approximately

every 25 hours of operation.

• Apply lithium grease into the gearbox through the

grease nipple (18) after 25 hours running (Fig X).

Air Filter

CAUTION: NEVER operate this unit without

the air lter as dust and dirt will be sucked into the engine and damage it.

Accumulated dust in the air lter will reduce engine eciency, increase fuel

consumption and allow abrasive particles to pass into the engine. Remove the

air lter as often as necessary and maintain a clean condition of the lter and

cylinder ns.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gardenline YR-HT250 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info