Bedienungsanleitung Gardol GAK-E 20 Li OA (Seite 26 von 340) (Alle Sprachen)

735296

Zoom out

Zoom in

Vorherige Seite

1/340

Nächste Seite

- 26 -

If the battery pack still fails to charge, send

•

the charger and charging adapter

•

and the battery pack

to our customer service center.

To ensure that the Li battery pack provides

long service you should take care to recharge

it promptly. You must recharge the battery pack

when you notice that the power of the cordless

chainsaw drops.

6. Operation

6.1 Switching on/oﬀ

Switching on

•

Plug in the battery on the equipment.

•

Hold the chainsaw by the handles with both

hands as shown in Fig. 13 (thumbs under the

handles).

•

Press and hold the safety lock-off (Fig. 1/Item

5).

•

Switch on the chainsaw at the ON/OFF switch

(Fig. 1/Item 6). You can then release the safe-

ty lock-off.

Switching oﬀ

Release the ON/OFF switch (Fig. 1/Item 6).

The integrated brake will bring the running chain-

saw to a standstill within a very short space of

time. Always disconnect the mains plug when you

stop working, even if it is only for a short time.

Warning! Always carry the saw by the front

handle. If the saw is plugged in and you carry it by

the rear handle (which is where the switches are

located), then there is a risk that you could acci-

dentally press the safety lock-oﬀ and the ON/OFF

switch at the same time, and the chainsaw could

inadvertently start up.

6.2 Safety devices

Motor brake

The motor brakes the saw chain as soon as the

ON/OFF switch (Fig. 1/Item 6) is released or the

power supply is interrupted. This signiﬁ cantly

reduces the risk of injury that would otherwise be

present if the chain continued to run after being

switched oﬀ or disconnected.

Chain brake

The chain brake is a safety mechanism which is

triggered via the front hand guard (Fig. 1/Item 2).

If kickback causes the chainsaw to suddenly jerk

back then the chain brake trips and stops the saw

chain in less than 0.1 seconds. You must check

the operation of the chain brake on a regular ba-

sis. To do this, fold the hand guard (Fig. 1/Item 2)

forward and brieﬂ y switch the chainsaw on. The

saw chain must not start up.

Pull back the front hand guard (Fig. 1/Item 2) until

it engages to release the chain brake.

Danger! Never use the saw if the safety equip-

ment is not working properly. Never try to repair

safety related protection systems yourself – al-

ways have any work done by our service depart-

ment or by a similarly qualiﬁ ed workshop.

Hand guard

The front hand guard (which also acts as the

chain brake at the same time) (Fig. 1/Item 2)

and the rear hand guard (Fig. 1/ Item 14) protect

against ﬁ nger injuries resulting from contact with

the saw chain if the chain breaks because it is

overloaded.

7. Working with the chainsaw

7.1 Preparations

To ensure that you can work safely, check the fol-

lowing points before every use:

Condition of the chain saw

Inspect the chainsaw before the start of work for

damage to the housing, the power cable, the saw

chain and the cutter rail. Never use a chainsaw

which is obviously damaged.

Oil container

Fill level of the oil container. Even while working,

keep checking that suﬃ cient oil is in the system.

To avoid damaging the chainsaw, never run the

saw if there is no oil in the system or if the oil

drops below the “min” mark (Fig. 10/Item B).

On average, a single ﬁ lling will last around 15

minutes depending on the number of pauses in

cutting and the loads involved.

Saw chain

Tension of the saw chain, condition of the cutting

elements. The sharper the chainsaw, the easier

and more controllable it is to operate the chain-

Anl_GAK_E_20_Li_OA_SPK7.indb 26Anl_GAK_E_20_Li_OA_SPK7.indb 26 19.04.2016 15:06:1919.04.2016 15:06:19

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gardol GAK-E 20 Li OA Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info