Bedienungsanleitung Garmin Astro 430 (Seite 18 von 24) (Englisch)

657464

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Dog Device Battery Replacement Instructions

T5 Components

Back plate

Power key

Battery connector

Battery cover

Battery

Power connector

Removing the Old Battery

Before you replace the battery, you must remove all dirt, water,

and debris from the device. You must also have a small Phillips

screwdriver.

Remove the six screws from the outer edges of the back

plate.

NOTE: You should leave the two inner screws in place.

Pry off the back plate.

Disconnect the battery connector and power connector.

Remove the screws that secure the battery cover.

Remove the battery cover and the battery.

Remember the orientation of the battery. You must install the

new battery the same way.

After you remove the old battery, contact your local waste

disposal department to properly recycle the battery.

Installing the New Battery

Before you replace the battery, you must remove the old battery

(Removing the Old Battery, page 14). You also must have a

small Phillips screwdriver. You may need a small flat

screwdriver.

Install the new battery using the same orientation as the old

battery.

The connector

should face the end nearest the power key,

and the bump

where the wires connect to the battery

should face toward the side with the charging clip contacts.

Replace the battery cover.

Replace the screws to secure the battery cover.

Connect the battery connector and power connector.

You may need to use a flat screwdriver to help secure the

connectors.

Select the power key to test the connections.

When properly connected, a tone is emitted and the status

LED blinks green.

Turn off the device.

Verify the gasket located inside the bottom cover is fully

seated.

Replace the back plate.

Replace the six screws to secure the back plate.

After you install the new battery, charge the collar completely.

Replacing the T5 mini Dog Collar Device Battery

Before you can replace the battery, you must remove all dirt,

water, and debris from the device. You also need a small

Phillips screwdriver and the security screwdriver included in the

battery replacement kit.

Remove the screws from the L-shaped cover over the VHF

antenna.

Pry off the L-shaped cover.

Remove the screws from the outer edges of the back plate.

Pry off the back plate.

Grip the battery connector wires close to the connector, and

pull the connector perpendicular to the circuit board to

disconnect the battery connector from the device.

Grip the power connector wires close to the connector, and

pull the connector parallel to the circuit board to disconnect

the power connecter from the device.

Remove the screws from the battery plate.

Remove the battery plate.

Remove the battery.

The battery fits tightly. It may be necessary to pry the battery

out of the back plate using a non-sharp, non-metal object.

Install the new battery into the front enclosure with the label

side of the battery facing up, and the leading edge of the

battery placed under the charging contact ledge of the

device.

Replace the battery plate, and replace and tighten the two

screws.

14 Appendix

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin Astro 430 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info