Bedienungsanleitung Garmin Astro320 - DC50 (Seite 17 von 22) (Englisch)

589669

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

• Before you pair the ANT+ accessory with your Garmin

device, move 10 m (32.9 ft.) away from other ANT+

accessories.

• Bring the Garmin device within range 3 m (10 ft.) of the

ANT+ accessory.

• After you pair the first time, your Garmin device automatically

recognizes the ANT+ accessory each time it is activated.

This process occurs automatically when you turn on the

Garmin device and only takes a few seconds when the

accessories are activated and functioning correctly.

• When paired, your Garmin device receives data from only

your accessory, and you can go near other accessories.

DC 50 Battery Replacement Instructions

DC 50 Components

ÀBack plate

ÁPower key

ÂBattery connector

ÃBattery cover

ÄBattery

ÅPower connector

Removing the Old Battery

Before you replace the battery, you must remove all dirt, water,

and debris from the device. You must also have a small Phillips

screwdriver.

1Remove the six screws from the outer edges of the back

plate.

NOTE: You should leave the two inner screws in place.

2Pry off the back plate.

3Disconnect the battery connector and power connector.

4Remove the screws that secure the battery cover.

5Remove the battery cover and the battery.

Remember the orientation of the battery. You must install the

new battery the same way.

After you remove the old battery, contact your local waste

disposal department to properly recycle the battery.

Installing the New Battery

Before you replace the battery, you must remove the old battery

(page 13). You also must have a small Phillips screwdriver. You

may need a small flat screwdriver.

1Install the new battery using the same orientation as the old

battery.

The connector À should face the end nearest the power key,

and the bump Á where the wires connect to the battery

should face toward the side with the charging clip contacts.

2Replace the battery cover.

3Replace the screws to secure the battery cover.

4Connect the battery connector and power connector.

You may need to use a flat screwdriver to help secure the

connectors.

5Select the power key to test the connections.

When properly connected, a tone is emitted and the status

LED blinks green.

6Turn off the device.

7Verify the gasket located inside the bottom cover is fully

seated.

8Replace the back plate.

9Replace the six screws to secure the back plate.

After you install the new battery, charge the collar completely.

Replacing the Collar Strap

Before you replace the collar strap, you must remove all dirt,

water, and debris from the device (page 11).

1Pull the collar strap out of the GPS antenna, VHF antenna

guide, and the dog device.

You may need to push and pull the collar strap to properly

remove it. You may need to loosen the screw on the GPS

antenna case, but do not remove them.

2Thread the new collar strap through the dog device, VHF

antenna guide, and GPS antenna.

3If necessary, tighten the screws that secure the GPS

antenna case.

VHF Radio Information

This product may be used only on specific radio frequencies,

which vary depending on the country of use. See the product

packaging or go to www.garmin.com/astro-legal for details

regarding the radio frequency of this product.

Replacing the VHF Antenna in the Dog Collar Device

NOTICE

Do not excessively bend the band that connects the main

device case with the GPS antenna.

When the cover is removed, do not disturb the sealant opposite

the VHF antenna, because this can damage the waterproof seal

of the dog collar device.

Before you replace the VHF antenna, you must remove all dirt,

water, and debris from the device. Also, you need a small

Phillips screwdriver.

1Remove the 4 screws À from the cover over the VHF

antenna.

NOTE: You should note the location of the one short screw

Á.

Appendix 13

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin Astro320 - DC50 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin Astro320 - DC50

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info