Bedienungsanleitung Garmin ECHOMAP Ultra serie (Seite 31 von 52) (Englisch)

691420

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

From an applicable sonar view, select Menu > Sonar Setup

> Installation > Bow Offset.

Enter the distance measured, and select Done.

On the applicable sonar view, the forward range shifts by the

distance you entered.

Autopilot

WARNING

You can use the autopilot feature only at a station installed next

to a helm, throttle, and helm control device.

You are responsible for the safe and prudent operation of your

vessel. The autopilot is a tool that enhances your capability to

operate your boat. It does not relieve you of the responsibility of

safely operating your boat. Avoid navigational hazards and

never leave the helm unattended.

Always be prepared to promptly regain manual control of your

boat.

Learn to operate the autopilot on calm and hazard-free open

water.

Use caution when operating the autopilot near hazards in the

water, such as docks, pilings, and other boats.

The autopilot system continuously adjusts the steering of your

boat to maintain a constant heading (heading hold). The system

also allows manual steering and several modes of automatic-

steering functions and patterns.

When the chartplotter is connected to a compatible Garmin

autopilot system, you can engage and control the autopilot from

the chartplotter.

For information about compatible Garmin autopilot systems, go

to garmin.com.

Autopilot Screen

Actual heading

Intended heading (heading the autopilot is steering toward)

Actual heading (when in standby mode)

Intended heading (when engaged)

Rudder position indicator (This functionality is available only when a

rudder sensor is connected.)

Adjusting the Step Steering Increment

From the Autopilot screen, select Menu > Autopilot Setup >

Step Turn Size.

Select an increment.

Setting the Power Saver

You can adjust the level of rudder activity.

From the autopilot screen, select Menu > Autopilot Setup >

Power Mode Setup > Power Saver.

Select a percentage.

Selecting a higher percentage reduces rudder activity and

heading performance. The higher the percentage, the more

the course deviates before the autopilot corrects it.

TIP: In choppy conditions at low speeds, increasing the

Power Saver percentage reduces rudder activity.

Selecting the Preferred Heading Source

NOTICE

For best results, use the autopilot CCU internal compass for the

heading source. Using a third-party GPS compass can cause

the data to be delivered erratically and may result in excessive

delays. The autopilot needs timely information, and therefore

cannot often use third-party GPS compass data for GPS

location or speed. If a third-party GPS compass is used, the

autopilot will likely report loss of navigation data and speed

source periodically.

If you have more than one heading source on the network, you

can select a your preferred source. The source could be a

compatible GPS compass or a magnetic heading sensor.

From the autopilot screen, select Menu > Autopilot Setup >

Preferred Sources

Select a source.

If the selected heading source is unavailable, the autopilot

screen does not display any data.

Engaging the Autopilot

When you engage the autopilot, the autopilot takes control of the

helm and steers the boat to maintain your heading.

From any screen, select Engage.

Your intended heading shows in the center of the Autopilot

screen.

Steering Patterns

WARNING

You are responsible for the safe operation of your boat. Do not

begin a pattern until you are certain that the water is clear of

obstacles.

The autopilot can steer the boat in preset patterns for fishing,

and it can also perform other specialty maneuvers such as U-

turns and Williamson turns.

Following the U-Turn Pattern

You can use the u-turn pattern to turn the boat around 180

degrees and maintain the new heading.

From the autopilot screen, select Menu > Pattern Steering >

U-Turn.

Select Engage Port or Engage Starboard.

Autopilot 25

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin ECHOMAP Ultra serie Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin ECHOMAP Ultra serie

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info