Bedienungsanleitung Garmin Fenix 2 (Seite 19 von 26) (Englisch)

589540

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

The Garmin logos on the module and the strap should be

right-side up.

Wet the electrodes

on the back of the strap to create a

strong connection between your chest and the transmitter.

If the heart rate monitor has a contact patch

, wet the

contact patch.

Wrap the strap around your chest, and connect the strap

hook

to the loop

The Garmin logos should be right-side up.

Bring the device within 3 m (10 ft.) of the heart rate monitor.

After you put on the heart rate monitor, it is active and sending

data.

TIP: If the heart rate data is erratic or does not appear, see the

troubleshooting tips (Tips for Erratic Heart Rate Data).

Tips for Erratic Heart Rate Data

If the heart rate data is erratic or does not appear, you can try

these tips.

• Reapply moisture to the electrodes and contact patch.

You can use water, saliva, or electrode gel.

• Tighten the strap on your chest.

• Warm up for 5–10 minutes.

• Wash the strap after every seven uses (Caring for the Heart

Rate Monitor).

• Wear a cotton shirt or wet your shirt if suitable for your

activity.

Synthetic fabrics that rub or flap against the heart rate

monitor can create static electricity that interferes with heart

rate signals.

• Move away from sources that can interfere with your heart

rate monitor.

Sources of interference may include strong electromagnetic

fields, some 2.4 GHz wireless sensors, high-voltage power

lines, electric motors, ovens, microwave ovens, 2.4 GHz

cordless phones, and wireless LAN access points.

• Replace the battery (Replacing the Heart Rate Monitor

Battery).

Foot Pod

Your device is compatible with the foot pod. You can use the

foot pod to record pace and distance instead of using GPS

when you are training indoors or when your GPS signal is weak.

The foot pod is on standby and ready to send data (like the

heart rate monitor).

After 30 minutes of inactivity, the foot pod powers off to

conserve the battery. When the battery is low, a message

appears on your device. Approximately five hours of battery life

remain.

Setting the Foot Pod Mode

You can set your device to use foot pod data instead of GPS

data to calculate pace and distance.

Hold MENU.

Select Settings > Sensors > Foot Pod.

Select an option:

• Select Indoor when you are training indoors without GPS.

• Select Always On when training outdoors, when your

GPS signal is weak, or when you lose satellite signals.

Foot Pod Calibration

Calibrating your foot pod is optional and can improve accuracy.

There are three ways to adjust the calibration: distance, GPS,

and manual.

Calibrating Your Foot Pod by Distance

Before you can calibrate your device, you must pair your device

with the foot pod (Pairing ANT+ Sensors).

For best results, the foot pod should be calibrated using the

inside lane of a regulation track or an exact distance. A

regulation track (2 laps = 800 m or 0.5 mi.) is more accurate

than a treadmill.

Hold MENU.

Select Settings > Sensors > Foot Pod > Calibrate >

Distance.

Select Start to begin recording.

Run or walk 800 m or 0.5 mi.

Select Stop.

Calibrating Your Foot Pod by GPS

Before you can calibrate your device, you must acquire GPS

signals, and pair your device with the foot pod (Pairing ANT+

Sensors).

Hold MENU.

Select Settings > Sensors > Foot Pod > Calibrate > GPS.

Select Start to begin recording.

Run or walk approximately 1 k or 0.62 mi.

The device informs you when you have traveled far enough.

Calibrating Your Foot Pod Manually

Before you can calibrate your device, you must pair your device

with the foot pod (Pairing ANT+ Sensors).

Manual calibration is recommended if you know your calibration

factor. If you have calibrated a foot pod with another Garmin

product, you may know your calibration factor.

Hold MENU.

Select Settings > Sensors > Foot Pod > Calibrate >

Manual.

Adjust the calibration factor:

• Increase the calibration factor if your distance is too low.

• Decrease the calibration factor if your distance is too high.

ANT+ Sensors 15

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin Fenix 2 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin Fenix 2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info