Bedienungsanleitung Garmin Fleet 770 (Seite 5 von 24) (Englisch)

674189

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Getting Started

WARNING

See the Important Safety and Product Information guide in the

product box for product warnings and other important

information.

• Update the maps and software on your device (Updating

Maps and Software Using a Wi

‑

Fi Network, page 15).

• Mount the device in your vehicle and connect it to power

(Mounting and Powering the Garmin fleet Device in Your

Vehicle, page 1).

• Acquire GPS signals (Acquiring GPS Signals, page 1).

• Adjust the volume (Adjusting Sound and Notification Volume,

page 15) and display brightness (Adjusting the Screen

Brightness, page 2).

• Set up a vehicle profile (Adding a Vehicle Profile, page 2).

• Navigate to your destination (Starting a Route, page 3).

Garmin fleet 770 Overview

Microphone for hands-free calling

Volume control

Power key

Micro USB power and data port

Map and data memory card slot

3.5mm audio jack

Magnetic mount interface with 14 pin connector

Speaker

Mounting and Powering the Garmin fleet

Device in Your Vehicle

WARNING

This product contains a lithium-ion battery. To prevent the

possibility of personal injury or product damage caused by

battery exposure to extreme heat, store the device out of direct

sunlight.

Both the device and its mount contain magnets. Under certain

circumstances, magnets may cause interference with some

internal medical devices, including pacemakers and insulin

pumps. Keep the device and its mount away from such medical

devices.

NOTICE

Both the device and its mount contain magnets. Under certain

circumstances, magnets may cause damage to some electronic

devices, including hard drives in laptop computers. Use caution

when the device or its mount is near electronic devices.

Before you use your device on battery power, you should charge

it.

Plug the vehicle power cable

into the mini-USB port on the

mount.

Press the mount

onto the suction cup

until it snaps into

place.

NOTE: The mount and suction cup may already be

assembled in the package.

The Garmin

logo on the mount should face right-side up. It is

easiest to connect the mount and suction cup when the

hinged arm on the suction cup is closed. The mount and

suction cup fit tightly, and you may need to press hard to

connect them.

Press the suction cup to the windshield, and flip the lever

back toward the windshield.

Place the back of the device onto the magnetic mount.

Select an option:

• If your power cable has a vehicle power plug, plug it into a

power outlet in your vehicle.

• If your power cable has bare wire connectors, follow the

wiring diagram included with your cable to connect the

cable to vehicle power.

Turning the Device On or Off

• To turn the device on, press the power key, or connect the

device to power.

• To put the device in power saving mode, press the power key

while the device is on.

While in power saving mode, the screen is off and the device

uses very little power, but it can wake instantly for use.

TIP: You can charge your device faster by putting it in power

saving mode while charging the battery.

• To turn off the device completely, hold the power key until a

prompt appears on the screen, and select Off.

The prompt appears after five seconds. If you release the

power key before the prompt appears, the device enters

power saving mode.

Acquiring GPS Signals

When you turn on your navigation device, the GPS receiver

must collect satellite data and establish the current location. The

time required to acquire satellite signals varies based on several

factors, including how far you are from the location where you

last used your navigation device, whether you have a clear view

of the sky, and how long it has been since you last used your

navigation device. The first time you turn on your navigation

device, it may take several minutes to acquire satellite signals.

Turn on the device.

Getting Started 1

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin Fleet 770 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin Fleet 770

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info