Bedienungsanleitung Garmin Forerunner 25 (Seite 8 von 14) (Englisch)

629009

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

ANT+ Sensors

Your device can be used with wireless ANT+ sensors. For more

information about compatibility and purchasing optional sensors,

go to http://buy.garmin.com.

Putting On the Optional Heart Rate Monitor

NOTICE

The heart rate monitor may cause chafing when used for long

periods of time. To alleviate this issue, apply an anti-friction

lubricant or gel to the center of the module where it contacts

your skin. Do not apply anti-friction gel or lubricant on the

electrodes. Do not use gels or lubricants that contain sunscreen.

You should wear the heart rate monitor directly on your skin, just

below your sternum. It should be snug enough to stay in place

during your activity.

Push one tab

of the strap through the slot

in the heart

rate monitor module.

Press the tab down.

Wet the electrodes

on the back of the module to create a

strong connection between your chest and the heart rate

monitor module.

Wrap the strap around your chest and attach it to the other

side of the heart rate monitor module.

The Garmin

logo should be right-side up.

Bring the device within 3 m (10 ft.) of the heart rate monitor.

After you put on the heart rate monitor, it is active and sending

data.

Pairing the Heart Rate Monitor

The first time you connect a heart rate monitor to your device,

you must pair the device and sensor. After the initial pairing, the

device automatically connects to the sensor when you go for a

run and the sensor is active and within range.

NOTE: If your device was packaged with a heart rate monitor,

the device and sensor are already paired.

Put on the heart rate monitor (Putting On the Optional Heart

Rate Monitor, page 4).

Select .

Bring the device within 1 cm of the center of the heart rate

monitor, and wait while the device connects to the sensor.

When the device detects the heart rate monitor, a message

appears and appears solid.

Setting Your Maximum Heart Rate

The device uses your user profile information from the initial

setup to estimate your maximum heart rate and determine your

default heart rate zones. The default maximum heart rate is 220

minus your age. For the most accurate calorie data during your

activity, you should set your maximum heart rate (if known).

Select > Settings > User Profile > Max. HR.

Enter your maximum heart rate.

About Heart Rate Zones

Many athletes use heart rate zones to measure and increase

their cardiovascular strength and improve their level of fitness. A

heart rate zone is a set range of heartbeats per minute. The five

commonly accepted heart rate zones are numbered from 1 to 5

according to increasing intensity. Generally, heart rate zones are

calculated based on percentages of your maximum heart rate.

Fitness Goals

Knowing your heart rate zones can help you measure and

improve your fitness by understanding and applying these

principles.

• Your heart rate is a good measure of exercise intensity.

• Training in certain heart rate zones can help you improve

cardiovascular capacity and strength.

• Knowing your heart rate zones can prevent you from

overtraining and can decrease your risk of injury.

If you know your maximum heart rate, you can use the table

(Heart Rate Zone Calculations, page 7) to determine the best

heart rate zone for your fitness objectives.

If you do not know your maximum heart rate, use one of the

calculators available on the Internet. Some gyms and health

centers can provide a test that measures maximum heart rate.

The default maximum heart rate is 220 minus your age.

Foot Pod

Your device is compatible with the foot pod. You can use the

foot pod to record pace and distance instead of using GPS when

you are training indoors or when your GPS signal is weak. The

foot pod is on standby and ready to send data (like the heart

rate monitor).

After 30 minutes of inactivity, the foot pod powers off to

conserve the battery. When the battery is low, a message

appears on your device. Approximately five hours of battery life

remain.

Going for a Run Using a Foot Pod

You can run indoors using a foot pod to record pace, distance,

and cadence. You can also run outdoors using a foot pod to

record cadence data with your GPS pace and distance.

Install your foot pod according to the accessory instructions.

Select .

If necessary, turn off GPS (Training Indoors, page 2).

Activate the foot pod by taking a few steps.

Bring the device close to the sensor, and wait while the

device pairs to the sensor.

When the device detects the foot pod, a message appears.

After the initial pairing, the device automatically connects to

the sensor when you go for a run and the sensor is active

and within range.

Select Start to start the timer.

Go for a run.

After you complete your run, select to stop the timer.

Foot Pod Calibration

The foot pod is self-calibrating. The accuracy of the speed and

distance data improves after a few outdoor runs using GPS.

4 ANT+ Sensors

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin Forerunner 25 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin Forerunner 25

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info