Bedienungsanleitung Garmin Fusion MS-RA60 (Seite 3 von 4) (Englisch)

772775

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

Dimension Drawings

Side View

40 mm (1 37/64 in.)

127 mm (5 in.)

A Sports model speaker is shown, but the dimensions are the

same for the Classic model.

Front View

176 mm (6 15/16 in.)

A Sports model speaker is shown, but the dimensions are the

same for the Classic model.

Back View

176 mm (6 15/16 in.)

156 mm (6 1/8 in.)

Cleaning the Speakers

NOTE: When mounted correctly, these speakers are rated IP65

for protection in the harsh marine environment from the front of

the speaker. They are not designed to withstand high pressure

water spray, which may occur when you wash down your

vessel. Failure to carefully spray-clean the vessel may damage

the product and void the warranty.

NOTICE

Do not use harsh or solvent-based cleaners on the speakers.

Using such cleaners may damage the product and void the

warranty.

1Clean all salt water and salt residue from the speaker grille

with a damp cloth soaked in fresh water.

2Use a mild detergent to remove a heavy buildup of salt or

stains.

Troubleshooting

Before you contact your FUSION dealer or service center, you

should perform a few simple troubleshooting steps to help

diagnose the problem.

If the FUSION speaker has been installed by a professional

installation company, you should contact the company so the

technicians can assess the problem and advise you about

possible solutions.

There is no sound coming from the speakers

• Verify that all connections from the source device and/or the

amplifier are connected correctly to the speaker terminals.

The system lacks bass or high frequencies

• Verify that the correct wire polarity is observed between the

source and speakers.

The wires should be connected positive to positive and

negative to negative.

• Verify that the speakers are attached firmly to the mounting

surface.

The audio is distorted

• Verify that the source volume is not too loud for the speaker,

and reduce the volume if necessary.

• Verify that the panels surrounding the speaker on the vessel

are not rattling.

• Verify that the source device and/or the amplifier are

connected to the speaker terminals correctly.

• If the speaker is connected to an amplifier, verify that the

input level of the amplifier is matched to the output level of

the stereo. For more information, see the manual for the

amplifier.

The LED lights will not turn on

• Verify that all wiring connections are correct and tight.

Specifications

Max. power (Watts) 80 W

RMS power (Watts) 20 W

Efficiency (1 W/1 m) 88 dB

Frequency response (+ 3 dB) 45 Hz to 16 kHz

Min. mounting depth (clearance) 43 mm (1 11/16 in.)

Mounting diameter (clearance) 130 mm (5 1/8 in.)

Impedance 4 ohm

Amplifier power-rating

recommendation

From 20 to 40 W RMS, playing

music

EL Series Installation Instructions 3

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin Fusion MS-RA60 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin Fusion MS-RA60

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info