Bedienungsanleitung Garmin GMR 24 (Seite 6 von 12) (Englisch)

522254

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

Garmin Radome Installation Instructions

Cable Runs

Route the cables as needed, depending on the type of mount you are using. It may be necessary to drill 31.7 mm (1.25") holes for routing the

power or network cable. Garmin provides a rubber cable grommet which may be used to cover a cable installation hole. The grommet does

NOT provide a waterproof seal. To waterproof the grommet, apply a marine sealant. Additional cable grommets can be purchased through

Garmin or a Garmin dealer.

When installing the power and network cables, observe the following:

• It is not recommended to cut the RJ-45 marine network cable, but the Garmin radome package includes a eld install kit if it is necessary to

do so. Make sure you save the end you cut. It is important that the wires are connected to the new RJ-45 connector the same way.

• To ensure safety, use the appropriate tie-wraps, fasteners, and sealant to secure the cable along a route and through any bulkhead or deck.

Avoid running the cables near moving objects, high-heat sources, or through doorways and bilges.

• Avoid installing the cables next to or parallel to other cables, such as radio antenna lines or power cables. This is essential to avoid

interference to or from other equipment. If this is not possible, shield the cables with metal conduit or a form of EMI shielding.

• Install the power cable as close to the battery source as possible. A minimum of 10.5 VDC is required during radar turn-on and operation.

Reference the wire gauge table on the previous page when using extended runs of wire between the power cable and the battery.

Final Wiring Connections

Making the nal wiring connections

1. ConnecttheBlackground(-)wiretothevessel’snegativepowerterminal.

2. ConnecttheRedpower(+)wire(withfuseholder)tothevessel’spositivepowerterminal.

Do not cut the fuse holder from the red wire. The fuse holder must remain in place for the Garmin radome to function correctly. Removing

the inline fuse holder may damage your boat's circuitry.

3. Forastand-alonenetwork(chartplotterandradaronly),attachtheRJ-45marinenetworkcabletotheRJ-45socketonthebackofthe

chartplotter.Foranexpandednetwork(chartplotter,radar,GMS10,etc.),attachtheRJ-45marinenetworkcabletoanopenRJ-45socket

ontheGMS10networkportexpander.TightentheRJ-45lockingringclockwiseuntilitisrmlysealed.

If you are using a Garmin GPSMAP 4000 or 5000 series chartplotter, you may not need a GMS 10 network port expander. The GPSMAP 4000

and 5000 series chartplotters have multiple RJ-45 sockets.

Stand-alone Network

Garmin radome

GPS 17/17X

Garmin

Chartplotter

When using the Garmin radome with a stand-alone network, the chartplotter and GPS antenna (GPS 17) must be installed according to their

installation instructions. This diagram only shows how a Garmin radome communicates with a stand-alone network and does not illustrate the full

wiring needs of the chartplotter or GPS 17/17X.

Both the Garmin radome and Garmin chartplotter must be connected to a power source according to their installation instructions. This diagram

only illustrates the network data connections.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Garmin GMR 24 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Garmin GMR 24

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info