583732
97
Zoom out
Zoom in
Vorherige Seite
1/112
Nächste Seite
Comment memory full - The waypoint comment memory is full. You
must delete existing waypoint comments
before adding new ones.
Configuration reset - The GNC 250 has detected a failure in its
installation configuration memory. Data from
the user memory has been used to reset the
configuration. Check the installation settings
for correctness. If the message persists, the
unit is not usable and should be taken to an
authorized service center for repair.
Data card failed - The GNC 250 has detected a problem with
the data card. The data is not usable and the
card should be returned to Jeppesen or an
authorized GARMIN service center.
Data card write fail - The user data card failed to program. The
card should be returned to an authorized
GARMIN service center.
Degraded accuracy - The GNC 250 has detected poor satellite
geometry while RAIM is not available.
Additional cross-checking with a secondary
navigation source should be performed to
verify the integrity of the GPS position.
Do not use for nav - The GNC 250 is in the simulator mode and
must not be used for actual navigation.
EEPROM write fail - The GNC 250 has detected a failure while
programming its installation configuration
memory. The unit is not usable and should
be taken to an authorized service center.
Final altitude alert - The suggested altitude is within 1000 feet of
the final altitude entered on the VNAV
Planning page.
Fuel/Air input fail - The fuel and/or air data input is not available
to the GNC 250. Check the I/O settings or
fuel/air data system installation.
Inside SUA - You have entered a Special Use Airspace.
Invald CPA wpt _____ - The closest point of approach cannot be created
from the waypoint entered on the CPA Page.
This occurs when the computed point does not
fall on one of the route legs, or when a unique
waypoint name for the closest point of approach
cannot be found.
Invalid copy route - A non-empty route was selected for a copy
operation. A route must be empty before
another route can be copied to it.
Invalid CPA route - The selected route contains less than two
waypoints and cannot be used for CPA oper-
ations.
Invalid SAR route - The selected route does not contain exactly
two waypoints and cannot be used for SAR
operations.
87
SECTION
D
MESSAGES &
ABBREVIATIONS
250 real 7/14/98 9:33 AM Page 87
97

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Garmin GNC 250 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info