584001
47
Zoom out
Zoom in
Vorherige Seite
1/124
Nächste Seite
400 SERIES INSTALLATION MANUAL Page 4-11
P/N 190-00140-02 Page Rev L
4.6 SERIAL DATA
4.6.1 Serial Data Function
4.6.1.1 RS-232
The 400 Series unit is capable of interfacing with other aviation instruments by transmitting RS-232 Type
1 (often known as ARNAV format) and Type 2 (often known as Northstar format) data on the GPS RS 232
OUT 1 port. The data consists of the following (refer to Appendix C for a detailed data format
description):
Current latitude, longitude, and GPS altitude in feet (see Note below)
Current velocity vector (ground speed and direction of velocity vector over the ground)
Distance, bearing, desired track, and cross track error to destination waypoint
Destination waypoint identifier, sequence in route, position (latitude and longitude), and magnetic variation
Magnetic variation and navigation and warning status
NOTE
Aviation RS-232 data may be transmitted with or without the current GPS altitude in feet. Refer to section
5.2.2.
The 400 Series unit can receive pressure altitude, air data, and fuel data from certain systems on the GPS
RS 232 IN 1 port.
The 400 Series unit can communicate with a Ryan TCAD 9900B system using the GPS RS 232 OUT 2 and
GPS RS 232 IN 2 lines to display traffic information on the 400 Series unit.
If two 400 Series units are installed in an aircraft, the GPS RS 232 OUT 3 and GPS RS 232 IN 3 lines may
be cross-connected to crossfill flight plans and user-defined waypoints from one 400 Series unit to the
other.
The 400 Series unit can communicate with a BF Goodrich WX-500 Stormscope using the GPS RS 232
OUT 4 and GPS RS 232 IN 4 lines to display lightning strike information on the 400 Series unit.
4.6.1.2 ARINC 429
The data output on the GPS ARINC 429 OUT port depends on the configuration (refer to section 5.2.1).
Below is a list of the configurations and the labels output for each one:
1. ARINC 429
2. GAMA 429
3. GAMA 429 Graphics
4. GAMA 429 Graphics w/Int
Label # Parameter Name 1234
001 Distance to Go (BCD) ••••
002 Time to Go (BCD) ••••
012 Ground Speed (BCD) ••••
074G Data Record Header
075G Active Wpt From/To Data
100 Selected Course 1
100G Selected Course 1
113G Message Checksum
114 Desired Track (True) ••••
115 Waypoint Bearing (True) ••••
116 Cross Track Distance
116G Cross Track Distance
121 Horizontal Command (to Autopilot) ••••
125 Greenwich Mean Time (BCD) ••••
147G Magnetic Variation
47

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Garmin GNS 430 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info